Have you checked the fuse?
Several reasons for this; review the Service Manual Jeep ZJ Secc 8K Windshield Wiper and Washer Systems for inspect and testing.
Good job.
SOURCE: windshield wipers on pt cruiser
the pump wire is probably not making good connection with the pump that is why the washer fluid wont work try and clean the connection. the pump is located under the fill tank
check for a bad relay for the wipers not working. the relay will be under the hood or under the dash next to the fuses. the cover will tell you what piece is the relay. the relay controls the delay in the wipers so that is probably bad and you can get them at napa for cheap. and simple to install its just like a fuse.
SOURCE: 1990 GMC Sierra 1500 pickup. Windshield wipers, Cruise Control
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
SOURCE: Rear windshield washer motor works, but no fluid comes out
Rear washer may have it's own reservoir . Can you hear a pump humming when you activate the washer? Look in the under flooor compartment
SOURCE: Washer fluid for windshield wipers stop working on
This could be one of an assortment of problems:
- bad washer pump
- blown fuse for washer pump
- clogged/loose washer hose
- loose/corroded electrical connection
- no fluid in reservoir
- clogged nozzle
- bad washer switch
- etc.
.
.
.
402 views
Usually answered in minutes!
×