At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Item 2,3,4,5 relate to each other that s camshaft and crankshaft position sensors. Since both already show a malfunction code, it would be advisable to change.
Sometimes other codes show up because there is a relation but not that the item is bad.
Possibly faulty throttle position sensor. Also gooked up EGR valve assy, allowing unwanted air in at the base of the TBI unit, therefore making engine rough at low RPMs
good luck
try adding some lucas fuel treatment to your gas tank to clean those fuel injectors. sounds like you've done everything else i would suggest. hope this helps!!!
p0560 is system voltage problem. open or short between the battery positive and the ecm.CHECK ALL FUSES. dosnt matter what they are labeled under dash and under hood replace any that are bad and retry to start. no start then check voltage to ecm grounds to. i dont have a wireing diagram to give you but for a small fee or free the dealer can make you a copy.make sure all the wires that go to battery terminals are not corroded and are making good contact [verified with volt meter]. if after all checks ok then replace ecm. as a side note i havent had to change one ever.
crank shaft sen. is easy enough to change.its mounted near timing chain cover,cam sen.is somewhat harder,its in the distributor,id doubt that both are defect
HI..
Tha crank position sensor On your astro is located.
On front of the engine on timing cover, left side.
Behind the crankshaft pulley. with a connector of 3 wires.
×