2000 buick lesabre need to take passenger side inside door panel off to fix electric windon

PWR WDO - 30amp circuit breaker , DRV -MDL 10amp fuse - both are located in the rear fuse box .
Fuse Block Rear
Under the left side of the rear passenger compartment seat

study the new fender and where there is a bolt hole then that is where you will find the bolts to remove on the old fender . They will normally be along the top inside , at the bottom near the door and around the bumper and up the panel that the door hinges are attached to

coulb be the control switch on your panel you can take the door panel off and check for loose connections and try to test for continuity. if you dont know how take it to a shop and have them diagnose the electrical. im quite sure it the switch that burnt out

Usually a blend door problem.
Doors under the dash direct air thru the system.

THE PROBLEM SOUNDS LIKE LOOSE WIRING CONECTIONS IN THE DRIVERS DOOR , BEST THING TO DO IS HAVE A LOOK OPEN UP DOOR PANEL AND CHECK ALL CONECTIONS, GOOD LUCK

Sometimes you have to make your own......neatly done......in a non important area.......access hole when doing work on doors.
Just make it look factory and only as big as needed.

Vent door between the two sides isn't opening or the flex hose going between the two is off.

Hello, NO you don't have to disarm airbags for glass.
You can pry off the door panel with big flathead screw driver. The panel is held on by plastic tabs that pry off and you can press them back on with fingers.
Before prying off panel, you should pry off electric window button panel. Also remove any screws that are visible. Sometimes the arm rest has little plastic covers with screws underneath it.
This is actually easier than it sounds.
Just remove any visible screws, and pry it off and lift up and she'll come off.

fault temp sensors
still can be a worn or stuck shaft flap at the actuators
or actuators is still faulty

try jumping the drivers and passenger side door switches -jeff