Im trying to connect my pioneer radio to my hyundai tiburon GT 2003, and i need to know what color wires on the radio go to what color wires on the cars wiring harness

Question edited for clarity.
Question moved to model category.

2003 Hyundai Tiburon Car Radio Wiring Chart - MODIFIEDLIFE

MODIFIEDLIFE https://www.modifiedlife.com > 2003-hyundai-tiburon...
Our 2003 Hyundai Tiburon radio wiring diagram shows you all the radio wire colors and what they do. Table of Contents. 2003 Hyundai Tiburon Radio Wiring Diagram ...

Hyundai Tiburon 2003-06 - Scosche

Scosche https://www.scosche.com > media > guides PDF AMPLIFIER LOCATIONS: VEHICLE MAYBE EQUIPPED WITH FACTORY AMP. LOCATED ON DRIVER SIDE PANEL ON FRONT OF REAR. SPEAKER. W ...

I need the wiring diagram for a infinity model h285jcbl 2003 car radio and amp

Hello
The engine and transmission in this cars drivetrain are fully electronically controlled by a computer called the PCM (Power Train Control Module). Whenever a problem like this occurs the computer stores a record of the problem in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s)

Is fuse 29 the one you say is good? If that fuse is good, check your tail lights. If the tail lights are not working either, check the TAIL LAMP fuse in the engine compartment relay box.
There are 2 different wiring diagrams depending on if you have the amplifier or not. If you have only the basic radio, it would not have the amp. If you have a premium option, it would have the amp.
There is also another wiring color code I got from another website that's different--more like the standard colors. I'm going to include that color code as well in case you find the colors don't match the diagrams.
In the diagrams, there are actually 2 wires that run the light on the radio. One is green and one is brown with a white stripe. An aftermarket CD player will probably not have any wires for the light and just have it come on when the radio is on--day or night. So, if they connected those factory wires anywhere, that may be your problem.
I have pasted all of the relevant wiring diagrams below, though they may be hard to read because of picture size policies at FixYa. Please let me know if you have more questions.




Possible alternate color scheme:
Radio Constant Wire 12V+: Red
Radio Ignition Switched Wire 12V+: Yellow
Radio Ground Wire: Black
Radio Illumination Wire: Pink/Black
Radio Dimmer Wire: n/a
Radio Antenna Trigger Wire: n/a
Factory Amplifier Turn On Wire: n/a
Left Front Speaker Wire (+): White
Left Front Speaker Wire (-): Brown
Right Front Speaker Wire (+): Black
Right Front Speaker Wire (-): Yellow
Left Rear Speaker Wire (+): Blue
Left Rear Speaker Wire (-): Red
Right Rear Speaker Wire (+): Green
Right Rear Speaker Wire (-): Orange

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

RADIO 12V - red +
RADIO GROUND - black -
RADIO SWITCH - yellow +
RADIO ILLUMINATE - green/orange +
LF SPEAKER + white - brown
RF SPEAKER + yellow - black
LR SPEAKER + red - blue
RR SPEAKER + green - orange

http://www.newtiburon.com/forums/showthread.php?t=102241&highlight=bcm

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Seriously don't use the factory alarm system / keyless entry.

While my car was under warranty, the alarm malfunctioned and it wouldn't disarm. The solution was to have the car towed to a dealership and install a new BCM. This would have cost me over $1,000 - and it's not an isolated case.

Don't get a Hyundai key fob. Have an after market alarm / keyless entry installed. It will be cheaper & easier.

My factory radio was a bit buggy itself. However, I bought a new Pioneer 6.1" touchscreen, wired it up, and I have no problems with that. I'm sure you can find a factory replacement unit for a good price but you might as well upgrade.