Accelerated and car began shaking. Had to pull over. Had husband drive it. It did the same thing but stopped when he pressed the brakes

Ur fuel delivery cud hav issue. Clean carb w BG sold in boatshops. Inspect ignition components fir wear. Buy a clymer or haynes manual for conplete repair

run the fault codes and look for problem cam or crank position sensor
could be a problem engine mount that is being started by a misfire

it may sound stupid but if the air filter is dirty it wont get enough air so it will shake badly telling you for experience

Try to bleed excess air on the brake line, you'll find the bleeder nip just behind the disc brake

Hello, sounds like you may have a engine miss, things like spark plugs, plug wires, fuel injectors can cause a engine miss. you will need to have the system scanned for trouble codes. once a trouble code has been pulled form the system you will have a much better idea what the problem might be

take car to local part store they diagnose for free ....it might just need a tune the diagnose can tell you exactly what is causing the check engine light to come on

Start by having the code pulled for the check engine light and go from there.

Sounds like one of the universal joints on the drive shaft is going out.

Have your front brake rotor's cut or replace, there warp that why it shakes at stops.If your going to have them cut make sure they mic them, if to thin, they will warp again.

could be coming from 3 spots
1 engine mounts = mounts go bad try shaking the motor when its cold to see if you can hear it
2 brakes = sometimes brake hardware can come loose or rust away mo so in brake drums in the back
3 exhaust shield = there is a thin shield around parts of the exhaust while it cold shake the tail pipe to see if you hear it