Program remote 1996 chrysler lhs

Question edited for clarity.
Question moved to sub category.

Nothing for that model, lots for Intrepid.

https://www.google.com/search?q=1996+Chrysler+LHS.+Vacuum+line+diagram

..

I think many of these systems can be reset by hooking up battery, turning the key to "ON" but not to start, wait 15 minutes, turn key off, then try to start.

Here's a video on changing your front light Judd. Chrysler Sebring Headlight Bulb Replacement

• EGR valve for a 1996 Chrysler LHS

  Passenger side near the firewall. Look for a piece of plastic clipped to a metal bracket and the plastic will have EGR on it. This is a two piece system, follow the hoses for the other part. hope this helps .
  

30oz

idol air controler keeps car running at idol speed ,you can take it off and clean it with throttle body cleaner to get carbon off its located on throttle housing ,if this works or improves your problem at all get a new one...

the starter is on the right side of the motor down below the the air intake bolted to the transmission three bolts and it comes off

System operation
System will automatically lock all doors when vehicle is driven in excess of 15 mph
Pressing UNLOCK (on remote) once deactivates system and unlocks driver door only
Pressing UNLOCK (on remote) twice w/in 5 seconds deactivates system and unlocks all doors
Alarm/central locking functions can be altered using remote transmitter


Programming

Access data link connector (DLC)- druvers sude fascia
Switch ignition on
Jump DLC terminal 1 and ground
Ensure doors lock and unlock, indicating programming mode active
Press any button of each remote to be programmed
Ensure doors lock and unlock after each remote operation - indicating programming complete
Remove jump lead to exit programmming code

A maximum of two remotes can be programmed

clear the 1-3 buttons on your visor by holding them down until you do not see the blinking light next to it ,after the light shuts off you can take your remote and aim it at the mirror or visor where your 3 buttons are located ,while holding down the button of your garage door opener press the button on you visor/mirror that you want to program it take a few minutes but it can also be programed from the opener smart button ,but you have to get the button in the car to learning mode first , you also can check your owners manual and it will also have information on how to program and also your car dealer can also do it for you when you get your oil changed! i hope i was able to help you and if i was helpful please leave me a nice rating thank you Sincerely glenn mayer

Driver side at rear of engine next to oil pan goes into the bell housing.