How do i bleed the brakes on a 2005 taurus - 2004 Ford Taurus

Engine off.
Furthest from Master cylinder first working back to the closest.
Because of the ABS system you have to use a pressure system which pushes brake fluid into the caliper and up to the master cylinder. One benefit is that air bubble always want to head upwards, and the old way you are pushing them down.

Lots of videos, old way and new way.

https://www.google.com/search?q=bleeding+brakes+on+2018+Ford+Taurus+limited+edition

..

Passenger rear, driver rear, passenger front, driver front, hope this helps

You must bleed the antilock brake unit, that takes a special tool, so off to the brake shop or local Ford dealer.

release? explain what that means.
what parts were disconnected? MC, tell what you did.
brakes good, bleed, no bad
brakes bad, parts pulled, now bad bleed,???? just a clue.here.
if you open a fitting north of the ABS main unit, you will be in trouble.


did you read the FSM on PRIUS< if not why not>?
got ABS,? sure...
some cars with ABS, have very specail rules and steps for
bleeding ABS. , including factory scan tools that must modulate
the ABS solenoids to clear air !
RTM.
or alldata.com/
i bounce in and read now for you.
it says.
Bleeding the brakes requires the use of the Toyota Hand-Held tester, or other appropriate scan tool. Follow the operating procedures of the Toyota Hand-Held tester, or other appropriate scan tool when bleeding the hydraulic brake system.

Before fiddling any car with ABS, google your car
see what others did wrong.... save lots of grief.
and a tow to a shop.

Assuming you put everything together correctly, you may have let air in the system. Follow the brake bleeding procedure for your car. Becareful with ABS systems the fluid can be under very high pressure. Get pro help if you don't know how.

Please Check Fluid flow Divider Valve & Servo Unit.

There is a special tool required to bleed the brakes, it plugs into the ABS hydraulic control under the hood and holds the ABS valves open to remove the trapped air during bleeding, u will need to have the dealer bleed the brakes, they are most likely the only ones that will have this special too, but u can try an outside shop, I am sure Snap on tools makes this tool in the aftermarket tool catagory..

WHAT the hell are you talking about as you dont do any thing like taking off springs to bleed brakes as the bleeder is on the back of the cylinder and bleeding takes 2 minutes only

Ask for info befor you start playing it will save you days of work

replace front rotors and pads with new napa parts only that should fix the brake issue and make sure you bleed the brakes.

If the car has ABS, you will need to bleed it there also.