My toyota tacoma's abs light has been on for the last two weeks. I topped the brake fluid , what else can I do?

? If the brake light is on, check your break fluid level first & top it off. If not, check your break lights - one could be out. Last - it's likely your pads are worn down & need new breaks. Have it checked.

Locate the 16 pin Data Link Connector under the steering side.
To clear fault codes, switch off ignition, connect jumper wire between terminals TS (pin 12) and CG (pin 4). Switch the key on, then pump the brake pedal eight or more times in three seconds or less. When codes are erased, the ABS light should flash two times per second.

Switch off the ignition. Remove the jumper wire.
Hope that works.
If problem persists, contact a service personnel.

blown fuse and then poss alt brushes or reg out

ABS LIGHT AND MODULE TROUBLESHOOTING:

Anti lock brake system light comes up when there is issue with car brake systems. It can be low brake fluid or faulty ABS fuse or its issue with brake system or assembly. Your vehicles brake system needs inspection.

To troubleshoot these issues, I suggest you to refer the help links provided below. There are direct links with accurate solution, for these specific issues.

Click the link below and follow the procedure: ------

All types of ABS LIGHT / brake problems and repairs

http://howtobyme.blogspot.com/2011/11/abs-and-service-light-comes-on.html

-------------------

ABS light stays on but brakes work fine?

http://howtobyme.blogspot.com/2011/11/abs-light-stays-on-but-brakes-work-fine.html

----------------

VCS and ABS lights go on and off intermittently on Lexus?

http://howtobyme.blogspot.com/2011/11/vcs-and-abs-lights-go-on-and-off.html

-------------

The ABS and Traction Control Lights stays ON dash of car?

http://schematicsdiagram.blogspot.com/2011/06/abs-and-traction-control-lights-stays.html

-------------

ABS & Brake lights warning indicator steady on dash and speedometer not working for Dodge Ram?

http://howtobyme.blogspot.com/2011/11/abs-brake-lights-warning-indicator.html

-----------------------

Battery Light and ABS Light on Dash

http://whoisbyme.blogspot.in/2012/07/battery-light-and-abs-light-on-dash.html

-------------

Sometimes ABS light comes on while Driving?

http://howtobyme.blogspot.com/2011/12/sometimes-abs-light-comes-on-while.html

-----------

How Anti-Lock Brakes Work?

http://technoanswers.blogspot.com/2011/11/how-anti-lock-brakes-work.html

-------------

Brake System Troubleshooting?

http://technoanswers.blogspot.com/2011/11/brake-system-troubleshooting.html

-------------

Anti-lock brake light stays on all the time?

http://technoanswers.blogspot.com/2012/01/anti-lock-brake-light-stays-on-all-time.html

-------------------

ABS light comes on and Car makes Grinding noise?

http://repairhelpcenter.blogspot.com/2012/01/abs-light-comes-on-and-car-makes.html

---------------

ABS trouble codes for all models?

http://repairhelpcenter.blogspot.com/2011/11/abs-trouble-codes-for-all-1994-00-acura.html
------------

2008 Toyota Highlander: ABS warning light Blinking and OBD Error codes Coming?

http://technoanswers.blogspot.in/2012/05/2008-toyota-highlander-abs-warning.html

--------------

2003 Lexus ES: VSC, TRAC OFF, ABS lights ON?

http://technoanswers.blogspot.in/2012/04/2003-lexus-es-vsc-trac-off-abs-lights.html

----------------

2008 Toyota Highlander Hybrid: Warning Lights Abs, Vsc & Brake Are On?

http://technoanswers.blogspot.in/2012/04/2008-toyota-highlander-hybrid-warning.html

-------------

ABS & Brake warning lights remains steady on dash?

http://schematicsdiagram.blogspot.com/2011/12/abs-brake-warning-lights-remains-steady.html

------------

Can I drive the car without ABS fuse connected?

http://schematicsdiagram.blogspot.in/2012/02/can-i-drive-car-without-abs-fuse.html

-----------

Where is ABS/TCS module located on 2005 Cadillac Deville

http://schematicsdiagram.blogspot.com/2011/12/where-is-abstcs-module-located-on-2005.html

------------------

ABS motor keeps running?

http://schematicsdiagram.blogspot.com/2012/01/abs-motor-keeps-running.html

------------

When the car stops, abs pump turns ON?

http://howtobyme.blogspot.com/2011/12/when-car-stopsabs-pump-turns-on.html

-----------

Replacing ABS unit on Buick Century?

http://technoanswers.blogspot.in/2012/02/replacing-abs-unit-on-buick-century.html

----------------

2008 Toyota Tacoma: ABS causes Brake pedal fade?

http://technoanswers.blogspot.in/2012/04/2008-toyota-tacoma-abs-causes-brake.html

--------------

Toyota Camry: Premature ABS Actuation?

http://technoanswers.blogspot.in/2012/04/toyota-camry-premature-abs-actuation.html

-----------

How to replace ABS Modulator Control Unit on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-modulator-control.html

----------------

How to replace ABS Pump Assembly on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-replace-abs-pump-assembly-on.html

-----------

How to remove ABS Accumulator on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-accumulator-on-acura.html

---------

How to remove ABS Control Unit on Acura Integra?

http://repairhelpcenter.blogspot.in/2011/11/how-to-remove-abs-control-unit-on-acura.html

------------

These details will help.

Thanks.

Issue with your master line... Check for Rusty and Pinch Line along the Frame at the Back Check Rubber Line Joint for leaking Oil ..Check Level Gauge into Brake Container for bad connection

The Ebrake light comes on for low brake fluid also. Check your fluid in the master cylinder.

abs needs fluid and the door needs a new senor or the wires are touching cause the button works on a circuit so if the wires touch it will turn on

Check the brake light switch, the button on it may be stuck in.
It's under the dash, near the top and back side of the brake pedal.

Check the brake fluid level.

Your dealer is not lying to you.
All of the Toyota product line with ABS has this phenomenon. What Toyota has done is incorporate "Brake Force Distribution" into the braking system. What that means is there is now a sensor on the brake pedal/brake rod, going to the master cylinder. The sensor measures how FAST you press on the brake pedal. This activates the ABS pump, and supplies more brake fluid, harder, to reduce the time needed, such as a "panic stop"; the pedal travel is much longer than you are used to, because of the way they have to measure the speed of the rod being depressed. In actuality, this system is much better than the old system, as it also prevents wheel drag. It just takes a while to get used to. Really, there is nothing to worry about, I explain this same thing to my customers every week.

I hope this helps you out.

Thanks for choosing FixYa for assistance.