1988 Camry side mirrors do not work

Fuses for lights, radio, etc is located on the kick panel just to the left of the clutch. Difficult to see and reach so you have to get your head right down by the pedals. Fuses for things like the fuel pump, etc are located under the hood usually towards the front of the car on the drivers side.

Best to you.

Here you go:

https://www.autogenius.info/toyota-camry-1999-2000-fuse-box-diagram/

Sounds like the relay has gone bad (common problem on these trucks) there is no rebuild so you have to replace it (around $10) located under hood, passenger side, by air cleaner you'll see a bank of little "boxes" the fuel pump is the green one. Just go to your local parts store to get the replacement. You just unplug the old one, and plug in the new one. Do make sure the key is OFF when you do it.

there is a fuse at the rear of the radio so remove the radio and check that one first

Check to see if the mirrors share a fuse with another circuit, if fuse is good, check for 12v at the mirror, if no voltage check for 12v going to the power mirror switch. If no voltage check for 12v at the ignition circuit that feeds 12v to the power mirrors.

did you check power mirror fuse? if ok, remove your power mirror switch at the driver side and clean the contact area, take a test light and check all wires for good connection. one by one test the voltage output,-/+ by pressing the switch, if all wires have output -/+ , and mirrors still not working, remove the switch connector, find out the three wires going to power mirror and direct it to - and positive voltage alternately, if the mirrors move, repair the wire that cut on the moving area, if still not moving repair or replace the two motors inside the mirror

The blower fan is powered by a 30 amp circuit breaker.Its in the box at the pass kick panel. Is it getting power through it? The blower relay is powered through the GAUGE fuse 7.5 amp. Check ALL the fuses. There is a 30 amp fuse that powers the ign switch also. If you get the blower working I think everything else will work.

for radio

Visual Inspection Chart Mechanical Electrical

• Audio unit
• Antenna or antenna cable
• audio speakers mounting/speaker cones
• Radio ignition interference capacitor, radio frequency interference suppression bond

• Central junction box (CJB) fuses:
  • 19 (10A)
  • 12 (5A)
• Battery junction box (BJB) fuses:
  • 19 (40A)
  • 20 (40A)
  • 27 (10A)
• Connectors
• Ignition switch
• Circuitry
• Audio unit

for mirrors

Visual Inspection Chart Mechanical Electrical

• Exterior rear view mirror(s)
• Interior rear view mirror

• Central junction box (CJB) Fuse(s):
  • 8 (10A)
  • 16 (10A)
• Circuitry
• Exterior rear view mirror motor(s)
• Exterior mirror control switch
• Heated rear window switch

The problem can be the switch, mirror, or wiring. Assess the missor connector to see if voltage is coming to the connector when you try to adjust the mirror. If you are getting voltage, replace the mirror. If not, check the wiring, especially any additional connectors inside the door.

hi remarkable08;

When you turn the key to start, you should have 12 volts at the small terminal on the starter solenoid.

If you have 12 volts but no cranking the solenoid is not working. If you do not have any voltage on this
terminal there is a problem in the ignition key wiring. If you have no way to measure the voltage, your best bet is to remove the starter and solenoid, take it to an Auto Zone type store and have them check it for you. When you go to remove the starter, be sure to disconnect the ground lead on your battery first.

Hope this helps. Good luck Loringh PS Please leave a rating for me if appropriate. Thanks