Get a 1/4in or smaller diameter rigid ice machine hose thats the only way youll be able to bypass the polimer X inside the gas tank, so get about 10 ft feed it into the gas tank whille making a loop (not a knot) below the gas tank but have the tip of the hose higher than the gas cap to ensure that you dont get a mouth full of gas then lower the tube into a gas can and watch the car go empty and the gas can fill up
You don't. There is no drain plug. If you are pulling it out to replace a fuel pump you just drop it with the fuel in it.
If you have to empty the tank you have to **** the gas out. Best to pick up a cheap hose that has a siphon built in it. make sure the tank you are putting the gas into is below the tank on the car. Start the fuel flowing and let gravity take over.
Hope this helps
789 views
Usually answered in minutes!
×