Hope this helps
SOURCE: 2000 monte carlo how to replace water pump.last bolt
there should be holes in power steering pump pulley that when positioned correctly the bole should go through one of those holes, if not then you have to remove the pump
SOURCE: 2006 monte carlo stuck in park
sometimes if the steering wheel is locked it won't come out of park try applying on the brakes and at the same time move the wheel back and forth and if this does not work and you have tilt it may be a problem in the steering column
SOURCE: water pump
On the 3.4.... Drain coolant, remove drive belt guard, loosen pulley bolts, remove drive belt, remove pulley, remove water pump. Good idea to check the belt for cracks or wear when doing the pump replacement. Reverse the procedure to install.
SOURCE: belt diagram for a 2006 chevy monte carlo
There should be a decal on the bottom side of your hood, or somewhere in the engine compartment. If there isn't just put it on the crankshaft (bottom pulley) and go ribs to ribs, and flats to flats, and work your way around.
SOURCE: remove the power steering pump pulley on a 2003 monte carlo
you can either remove the steering pump to gain access,if there is no holes in PS pump pulley,you can rent a pulley puller....can be a ***** to get in and use them though....I will drill a hole in it for next time whenever I replace a pump on cars without ....
1,201 views
Usually answered in minutes!
you need to indicate which motor you have. there is a distint difference between the 3800 and the 3500
×