How do I replace the brakes on a 1995 sc400. - 1995 Lexus Sc 400

There are several steps:
1. Take out the center cup-holder (it pops out with a little tug upward). unscrew the 2 screws.

2. On the shifter (lower part) there is a cover that covers 2 screws, unscrew and remove the shifter knob.

3.Take a pick tool and lift the shifter bezel console (black) it also pops up.. there are 3 or 4 connecters (disconnect with a small flat head screwdriver)

4. Once the shift cover is removed, there are several screws and tabs holding the bezel trim down unscrew the screws and lift bezel trim up,

5. Disconnect the ash-tray (blue connector)

6. Disconnect the hazard signal control , volume control connector and the climate control connector.( On the left side)

7. There are 4 screws holding the the radio and climate unit cage to the dash frame. (unscrew)

8. Now it gets a little tight, pull the unit towards you slightly and disconnect to connectors for the climate control unit (on top) and the factroy radio (on the bottom).

9. Next remove the radio and climate control unit from the cage(screws on the sides).

10. Next you will need a new cage: Metra 95-8157B Double DIN Installation Kit for 1992-2000 Lexus SC300 and SC400 (Black)
by Metra Link: http://amzn.com/B001TJG7SA

11. You will need the following harness: Metra 70-8112 Radio Wiring Harness for Toyota Amp Integration 15 Pin by Metra
Link: http://amzn.com/B0002BEUBW and/or Metra 70-1761 Radio Wiring Harness For Toyota 87-Up Power 4 Speaker by Metra Link: http://amzn.com/B0002BEQJ8

12. Match the wires according to the metra kit and new radio instructions.

13. Next follow instructions in reverse for re-stall. GL.

your local auto parts store can give you your specific information, as can the parts desk person at your local dealership or possibly even an aftermarket repair shop by using an electronic component locator manual. your local auto parts store will probably be the most willing and friendly.

Open trunk and remove the back trim panel (4 vinyl screws/nuts), underneath you'll find access to your tail lights - remove those nuts and you will have access to the bulbs.

temp. sensor?

MY 1995 LEXUS SC400 TRANSMISSION WONT PULL IN ANY GEAR,,,(DRIVE L1,L2 OR REVERSE

did you bleed the brake lines?

No, not ABS at all. Your brake master cylinder is shot and needs to be replaced.

did you check the grounding points? if you have access to the wire diagram that would help. try measuring power at the fuse first. if theres power there then try the bulb socket. if theres no power there then you have a wiring problem.

i do theses regulators all the time . its not hard to change the motor . you may need to drill out the rivits and replace them with bolts and nuts

http://www.lexls.com/tutorials/ignition/sparkplugs.html

This should help, I did mine yesterday, it is a piece of cake... just make sure you have a good spark plug socket that fits VERY snugly on the extension,and make sure you have a LONG extension for the socket... I have a 10 inch one, and I wish I used one that was longer for the back plugs on each side... Oh, and be careful to not crack the plugs in there by over tightening them... I know that it says its for an LS400 but they both have 1UZ-FE engines so its the same thing...

And make sure to spend the extra money for the Good Plugs and Wires... I got NKG's for my '93 SC400... well worth it...