The Flashers all work Hazard and l & R signals or they all do not

There are two separate flasher blocks, one for hazards and one for turn signals, listen for the clicking with hazards on there usually right next to each other, when you find it swap the flashers around and see if the turn signals start working and the flashers quit.. Otherwise you could also be looking at a turn signal switch problem

Turn signals and flashers not working - MyTractorForum.com - The ...

www.mytractorforum.com/.../193023-turn-signals-flashers-not-working....

Jun 5, 2011 - My turn signals and flashers are not working on my BX1500. I can hear the ... I hear nothing when I depress the hazard button and no light.

Turn Signal and Flasher Repair JD4300 Recovered Part 7 ...

? 19:17
https://www.youtube.com/watch?v=UrLN5xzbOzY
May 9, 2014 - Uploaded by mars1952
Turn Signal and Flasher Repair JD4300 Recovered Part 7 ... I bought a 4310 new in 2004 and I know these are great tractors, not the ... I have a John Deere 4400 and I wouldn't mind putting a set of those on it to protect the lights. .... Ford Explorer 2003 - MyTurn Signals Stopped Working - Duration: 2:15.

Brake lights /rear hazard lights not working - Ford Truck ...

www.ford-trucks.com > ... > 1967 - 1972 F-100 & Larger F-Series Trucks
Jul 9, 2010 - After checking the brake lights I tried the emergency flashers and found that they are working in the front but not in the back. I do have rear turn ... 1995 F350 Brake Lights / Turn Signals not working
Jul 9, 2012
Turn Signals and Brake Lights Do Not Work
Mar 10, 2012
Turn Signal, Brake Lights, & Rear Hazard not working
Aug 3, 2010
Rear Turn Signals, Hazards and Brake Lights not working....
Aug 29, 200

Sounds like the turn signal flasher (lighting control module). It is used for both the turn signals and the hazard flashers. There is one type for cars with DRL and one for cars without DRL.

The hazard switch gets power from the horn fuse which is hot all the time, and from the turn signal fuse which is hot when the key switch is on. The turn signal switch gets power from the hazard switch and both use the same flasher.
So if the turn signals work but the hazard switch does not power the lights, and both fuses have power, I would say the problem is inside the hazard switch.

There are usually two flashers that are used on most cars. One for the turn signals and one for the hazard lights. They are usually located under the dash. If you don't know what they look like, then go to the parts store and ask to see a new one. Once you locate both of them, see if they have the same part number stamped on them. If they do, then switch them and see if the signals work.
REMEMBER : The key must be turned on for the turn signals to work in most cases. The hazard flashers will work with the key off.
If the signals work, then replace the turn signal flasher. I hope this information is helpful and thank you for using Fixya.com.

did you change the flasher relay ? it controls the flashers and the hazard

check fuse under dash, or may be a bad flasher. you'll find that right next to fuse box you should have 2 flashers one for turn signals @ 1 for emergency flashers

You did try switching flashers to see if any difference right? There's 2 in fuse panel, 1 for hazard & one for signals.

i have a similar problem but my left signal works, when i turn the right on it just does an annoying buzz sound. if you can think of any explination for such shinanogins help would be greatly appreciated