How do i check dodge neon 2004 codes? - 2004 Dodge Neon

SOURCE: Programming keyless remote for Neon 2004

There is a way to program a remote if there is already a valid remote. Unfortunatly if you don't have a valid remote the only way to get one programmed is at the dealership with their scan tool.

I have pasted directions for programming a remote if there is already a valid transmiter.


CUSTOMER PROGRAMMING For a customer to be able to program RKE transmitters themselves, at least one RKE transmitter must be programmed already. This procedure is to add additional transmitters. If all transmitters are lost, the DRB III® scan tool must be used to program the new transmitters.

1. Insert the key into the ignition switch, and turn the ignition switch to the RUN position without starting the vehicle (allow chimes to stop).
2. Using the RKE transmitter programmed to the RKE module, press and continuously hold down the UNLOCK button for 4-10 seconds.
3. Within the 4-10 second time range, continue to hold the UNLOCK button and press the PANIC button. Both buttons may then be released. Upon the PANIC button being depressed, the message for customer programming mode will be transmitted to the RKE module.
4. A chime will be heard to verify that the customer programming mode has been entered (allow 3 seconds to hear chimes).
5. Press and release any button on each transmitter that is to be programmed to the RKE module, including any transmitters which were previously programmed to the RKE module (with a maximum of four possible). After each transmitter is successfully programmed, a chime will be heard to verify that successful programming of the transmitter has occurred.
6. After thirty seconds, or upon the ignition switch being turned OFF, the RKE module will exit programming mode.

SOURCE: how do i change my fog lights to my 2004 dodge neon

you need to remove the 2 nuts from under the fascia that hold the assembly in. this will give you access to the bulb

SOURCE: CODES P0300 P0303

I,thank you for you help.i have a car is audi a A4 1.8 turbo 2000.the code is po300,po3001,po3002.misfire

SOURCE: my 2004 dodge neon sxt is giving me a p0340 code

A code P0340 could mean one or more of the following has happened:

• a wire or connector in the circuit could be grounded/shorted/broken
• the camshaft position sensor may have failed
• the PCM may have failed
• there exists an open circuit
• the crankshaft position sensor may have failed

• Visually inspect all the wiring and connectors in the circuit
• Check for continuity in the circuit wiring
• Check the operation (voltage) of the camshaft position sensor
• Replace the camshaft position sensor as required
• Check the crankshaft position circuit as well
• Replace circuit wiring and/or connectors as required
• Diagnose/replace the PCM as required

SOURCE: 2004 Dodge Neon SXT, added new battery need code to reset car

if you are the original owner, look in your paperwork. if you cant get to the original owner or they dont have the info, you can go to your dealer, and they can reset it for you. and charge you

or you can just start entering codes till it works, which will take you weeks or more.

good luck