2007 kia rondo.2007. P0011 camshaft position bank.1. Where is located

https://www.google.com/search?q=Nissan+P0011


P0011 Nissan See the error code p0011. it indicates the engine control module has determined that the bank 1 intake camshaft is more advanced than what the engine control module has commanded it to be. Jul 23, 2021

How to Fix NISSAN P0011 Engine Code in 4 Minutes [1 DIY ...

(1) Camshaft Position (CMP) Actuator Solenoid - Intake Bank 1
(2) Camshaft Position (CMP) Sensor - Intake Bank 1
(3) Camshaft Position (CMP) Sensor - Intake Bank 2
(4) Camshaft Position (CMP) Actuator Solenoid - Intake Bank 2
(5) Camshaft Position (CMP) Actuator Solenoid - Exhaust Bank 2
(6) Camshaft Position (CMP) Sensor - Exhaust Bank 2
(7) Generator
(8) A/C Compressor Clutch
(9) Camshaft Position (CMP) Actuator Solenoid - Exhaust Bank 1
(10) Camshaft Position (CMP) Sensor - Exhaust Bank 1

These codes have to do with the CVVT(continuously variable valve timing)solenoid. I guess it is a 2.4 liter engine, the solenoid is located right above the power steering pump at the #1 cylinder in the cylinder head. If it is the 3.5 liter it is located on top of each cylinder and is accessed after the intake plenum is removed. Either way, the solenoid controls valve timing of the exhaust cam via the solenoid which uses oil pressure to advance or retard the timing. The first step is to verify proper weight of oil and level. If the engine is over due for service, get it done. If the oil is not an issue, then the solenoid is becoming sluggish in advancing or retarding the camshaft and should be replaced.

Parts stores have parts locator charts which may show this

Error Code: P0011
Fault Location:
Camshaft Position (CMP), Intake, Bank 1 - Timing Over-Advanced/System Performance
Possible Causes:
-Valve timing.
-Mechanical fault.
-Camshaft position (CMP) actuator.
-Camshaft Adjustment Valve 1 faulty.

Well p0011 is a code for your camshaft position bank #1 so it could be the sensor or something more but i would start with a bank #1 camshaft position sensor

OK check the CMP sensor connector for cleanliness, sometimes oil can get in and disrupt the signal transmission to the ECU. Check the wire loom continuity all the way back from the CMP to the ECU. If the error code persists remove the cam sensor, clean its tip of any debris and refit.

P0011 - Intake camshaft position timing ( over advance bank 1 )
O0420 - catalyst system efficiency below threshold bank 1. Hope this was helpful.