2001 kia sportage power window diagram - Kia Cars & Trucks

SOURCE: hold lite and and a p1624 code on a 2001 sportage

Code number p1624 is MIL Request Signal from TCM to ECM. which means malfunction indication light(MIL) is requesting a signal from your engine control module(ECM) or Transmission control module(TCM) i would reccomend u take it to the dealership to get it checked out.

Greg Bernett

• 2993 Answers
• Posted on Jul 26, 2009

SOURCE: 1999 kia sportage timing marks

Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks

1. Align marks on camshaft pulleys with alignment marks on seal plate.
2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
   
3. Loosen tensioner lock bolt.
4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
8. NOTE: Replace tensioner spring if timing belt deflection is excessive.

1. Install lower timing belt cover.
2. Install upper timing belt cover.
3. Install power steering drive belt and adjust belt tension.
4. Install fan pulley.
5. Install generator drive belt and adjust belt tension.
6. Install A/C drive belt and adjust belt tension.
7. Install splash guard.
8. Install fan and fan shroud.
9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
10. Install fan shroud mounting bolts.
11. Install fresh air duct.
12. Connect hose to resonance chamber.
13. Connect battery negative cable.

SOURCE: I need a auto Ac WIRING DIAGRAM FOR A KIA SPORTAGE

Hi there,

Here is the wiring diagram of your AC







Regards,
Jeep Brainy

Greg Bernett

• 2993 Answers
• Posted on Oct 10, 2009

SOURCE: the power steering belt is broke on a kia sportage

I would replace it yourself....very simple to do! The belt is $13.00 Power Steering Pump Belt

1. Disconnect the negative battery cable.
   
2. Remove the A/C and alternator drive belts for access.
   
3. Loosen mounting lock bolt (A) and mounting bolt (B).
   
4. With tension released removed the belt.
   

1. Properly route drive belt around the pulleys.
   
2. Carefully pry on the power steering pump using a suitable lever. Adjust belt tension is 22 ft. lbs. (30 Nm) when measured at deflection point shown.
   
3. Retighten bolts (A) and (B) to 31 ft. lbs. (42 Nm).
   
4. Reinstall the A/C and alternator drive belts.
   
5. Connect the negative battery cable.
   

SOURCE: timing belt

My apologies for the delayed response. I am going back and answering questions that were never answered.
Click on the following Link. It has all the Diagrams for the Timing Belt you will need.
Before Clicking, let me know if this helped.
Again my sincerest apologies...

http://www.2carpros.com/car_repair_information/year/2001/make/kia/model/sportage/2001_kia_sportage_timing_belt_diagram_marks.htm