SOURCE: saturn crankshaft sensor
Right above the started. It can be removed from under the car withour taking the starer out. 5 minute job, one bolt
SOURCE: where is 2003 saturn ion thermostat?
FACEING the ENGINE It is At TOP RIGHT SIDE Close to Master Cylinder takes About 1 hour to Replace Have Fun its a EASY One
Please Dont forget to RATE ME Thank You
Remove the feed pipe
Installation Procedure
Install the thermostat and retaining sleeve with the dimple placed into the housing slotImportant: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump.
SOURCE: How do I fix or replace a idel sensor
You need to replace Coolant Temp sensor & connector.Yellow & Black wire located on cyclinder head under upper radiator hose at engine.
SOURCE: 2002 Camry won't accelerate
check throttle position sensor wire chewed up, broken wire or unplugged? check with volt meter mesure the voltage @ throttle positon sensor see if there's voltage goes up/down when u apply/release gas.
SOURCE: how do you change the downstream oxygen sensor in
Downstream O2 sensor is the O2 sensor after the Catalytic converter. Jack the car off the ground so you can get under it, disconnect the wire leads and with a close end wrench. Snake the wire leads through and wrench and place the wrench one the O2 sensor and with a hammer, tap the wrench to break lose the O2 sensor from the exhaust pipe. Once the O2 sensor has loosen up, just remove and install the new O2 sensor. Reconnect the wire leads, start the car and listen for any exhaust leaks. Once no leak has been determined, Place car back on the ground and go for test drive. Check engine light should go off after three start up and car has reached it's operating temperature and DTC codes will be erased after 100start cycle. Good luck and be safe.
57 views
Usually answered in minutes!
×