Turn it off prior to incline, then back on after completion.
Do yourself a favor an take it to a qualified repair shop . Shouldn't try an fix thing's you have no clue about .
SOURCE: Mass Airflow Sensor 2005 Chevy Malibu. 2.2 ltr.4 cyl.
The MAF is in the flex hose that delivers air to the engine, it has a 5 or 6 wire connector going to it.
SOURCE: MASS AIR FLOW SENSOR REPLACEMENT & DIAGRAMS
Very easy for the Mass Air Flow Sensor....it is in the duct between the throttle body and the air filter box. Just unclamp the tube and remove the old and replace with the new.
On your pack....I need the engine size.
SOURCE: mass air meter not reading vane postion
hey rob_andersen,
yes their is a way to replace the mass air flow. Get a can of brake clean or throttle cleaner, throttle cleaner is going to work best. remove the until and spray it down with throttle clean, let it dry for about 15 min. and reinstall it.
Now a little warning for you, IF their is no visual damage to the mass air flow then you can do this successfully. Now the reason why I always replace them instead of spraying them down is because is MOST cases the mass air flow will start acting up again. Sometimes it takes a weeks, sometimes months, sometimes years its hard to say.
But the worst you have to loose, is it doenst work an your out 5 bucks for the can of fluid.
SOURCE: 2002 chevy blazer 4.3l 4x4. Just changed out mass
2002 chevy blazer just started dieing out of no where. while im driving it just dies like i had just switch the key off in mid drive. when i sit for 10 to 20 min it starts just fine. theres no sign of overheating. battery is fine and i have antifreeze init. help me
SOURCE: misfire in cylinder 3
NO to the MAF Sensor Question, and Spark Plug Wires Or BOOT Will Cause Missfire. As For Mass Air Flow Sensor Easy Check is to Dissconnect it While Engine is Running And If ENGINE SMOOTHES OUT The Sensor is Bad
44 views
Usually answered in minutes!
×