I've replace the air bag module on my 2001 VX Commodore and now it won't start is there anything I can do to reset it at home without taking it to a workshop please

This question also edited for clarity.
This question also moved to Holden Commodore.

I answered this three days ago! You will have had an email Notification and also a Notification flag on the website

https://www.fixya.com/cars/t29943066-firing_order_diagram_3_6_v6_vx_commodore

Spoon feeding you the information, it is here.

https://forums.justcommodores.com.au/threads/firing-order-for-v6-vr.187760/

1 6 5 4 3 2 is the firing order

No. 1 is the front passenger side

1 3 5 are on the passenger side
2 4 6 drivers side

Front
1 2
3 4
5 6
Back

Here is your posting history

https://www.fixya.com/users/tracy-lee-ryan

....

Question edited for clarity and correct order of 'year make model ('stuff')'.

All in the link

https://www.google.com/search?q=2001+commodore+vx+firing+order+diagram

..

your VT /VX came out with a V8 engine
you need the engines ECU and the V8 gearbox
manual diff ratios can be optional

1997 -2002 engines will bolt in

you could go up the next commy V8 model it has roller rockers
you can have a v6 or v8 supercharged if you like

once all bolted in you need a mutt 2 diagnostic reader to reset all the keys and modules and immobilizer for it to start and run

http://forums.justcommodores.com.au/vt-vx-holden-commodore-1997-2002

try this just commodores forum
on the VZ 2004-- 2006
Forum VZ Holden Commodore 2004 2006

I only know of engine service message
clearance using the mode buttons on a VT.VX

i hope you are a lucky person because
any commodore transmission man or auto
driven without fluid would have taken some internal damage

Yes!!! You can replace it yourself.(Dont let others fool you into paying extra or telling you otherwise.)
-This is for pontiac grand ams 1999-2005 only.
-There are no frontal airbag impact sensors nor are there belt tensioners.
-The SRS system consists of only the (driver airbag) ,(passanger airbag),and the (airbag control module) in 1999-2005 grand ams.

If you crash/wrecked and airbags deployed you will need.
-Driver and Passanger airbags
-Airbag control module

You can buy cheap airbags from a local junkyard any year from 1999-2005 will fit.
You can also find an airbag control module for cheap at your local junk yard BUT YOU MUST FIND ONE WITH THE SAME (PART NO.) AND (SERV NO.) AS THE ONE YOUR REPLACING.The (part no.) and (serv no.) should be at top left of airbag control module.However it does (Not) have to match numbers under barcode or the numbers at the far bottom right of airbag control module.

After you get both airbags and airbag module
-Disconnect car Battery
-Replace airbags
-Replace airbag module (under passanger seat)
-Double check all connections and connect battery.

Congradulations!Your airbags should be back online.

Notes: Two torx 35 head screws hold the driver airbag, access is through two holes behind steering column.
To remove passanger airbag you have to remove glovebox it uses (7mm)screws.After you remove you will see a pair of (10mm)screws holding airbag.
To remove airbag control module First remove passanger seat 2(15mm).Then after removing you will notice a raises area kinda like a vertical bump.Take a razor blade to your carpet and cut it to explose the module underneath.
The airbag module is held by three screws depending on the year of your car it varies.Most likely 3 (10mm).

Could be several causes... but the result is consistent - when the light is on the air bag is disabled

The motion sensor board has a failure - or one of the crash sensors has failed - so the motions sensor board is not receiving the desired signal. To prevent an accidential firing of the bag, the system disables the airbag and turns on the light....

THE AIR BAG CONTROL MODULE IS ON THE FLOOR AHEAD OF THE CONSOLE.BECAREFUL YOU CAN CAUSE AIR BAGS EMPLOYMENT ACCIDENTALLY.THEY ARE DANGEROUS.THE DEALERSHIP HAS TO RETRIEVE AIR BAG FAULT CODE.

you need to takee into a certified mechanic , if you mess with the air bag system and it deploys no one will work on it . the cost to replace your airbag system could be easily 2500.00

If you are replacing the air bags, you should replace the front left and right crash sensors, the spiral cable under the steering wheel, AND the center air bag sensor, which is in front of the console. If your car has seat-belt pretensioners and force limiters, you may have to replace them also. You will know this if the seat belts are "locked up". If you do not replace all of the parts, you may get a air-bag code, and the air bags may not deploy next time.

I had a problem with my ambient air temperature sensor and the passenger side door lock. I was told that I needed a control module and that my battery was bad. When I replaced the battery, the module reset and everything started working again. Try disconnecting the positive cable from your battery and or having it checked at a local auto parts store.