SOURCE: CENTRAL LOCKING
Check your remote batteries.Listen for any sounds coming from the passenger door lock when operating the drivers door switch.The lock could be faulty.Have a diagnostic check done at a dealer to tell you whats wrong , this is normally free , before stripping anything..
SOURCE: 1996 4.0 Range Rover won't unlock
This car is in super lock mode... when you press remote 2times to lock or when you lock with remote and try to unlock using key manually.
there is a 4 digit number to open the door, its like opening a safe, starting from the left(key in car door) it goes L/R/L/R. so if number code is 1234..... left 1, right 2, left 3, right 4.
or if this too troublesome you can ask landrover dealer to remove the KEYCODE.
happy trying.....
adrian/kk.
SOURCE: warning lights
My 2002 Disco was doing the same problem, I checked the battery terms. and realized they were loose so when i was driving down the road and hit even the slightest bump all my warning lights came on. i changed out the terminals and made sure they were tight and have not had any problem since. I hope this helps Tracy in Vegas
SOURCE: My P38 Range Rover wont start
Hi Adam,
Bring your vehicle to an auto parts or battery store. Ask if they could perform a 'Load Check' on your battery. This not only checks the voltage, but also the amps, as if it were under the load of turning your engine.
It takes a few seconds and the results are pass or fail. Fail means it's time for a new battery. Pass means we need to look elsewhere.
Comment back the results.
Hope you find this to be very helpful
Mike
SOURCE: how do i turn off the brake warning light on range rover 2004
You can reset this fault code using the buttons on your dash - you don't need a dealer to do this. As you already know, you need to replace your pads and the brake wear sensor - this is a sacrifical item. Once this is done, do the following:-
Using the buttons on your dash - there are 2 - one on the LHS (Trip reset) and one on the RHS (In between Tacho and temp gauge)
*Press and hold Right button and turn ignition to first position (I or Accessory)Display should show "Check Control OK" then a short time later "Test Nr.01"*Press the Left button and you should see the car info in the display. Add the last FIVE digits of the car identity number together (NOT all 6!) to get a unique ID for your car.*Press the Right button repeatedly until you see "Test Nr.19"*Press and hold the Left button until you see the number matching the unique ID you calculated, then release.*Press the Right button to select this.*Press the Left button repeatedly until you see "Test Nr.21" - Reset All Defect Codes*Press Right button to reset the codes.Done!
550 views
Usually answered in minutes!
×