- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Try to reset system with key fob by locking and unlocking doors. Sometimes using the key to unlock and lock the drivers door will also reset the system
Your Focus may be equipped with the autolock feature. Try this:
To deactivate/reactivate the autolock feature using the power door unlock control
You must complete steps 1-7 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds.
1. Turn the ignition key to ON.
2. Press the power door unlock control three times.
3. Turn the ignition key from ON to OFF.
4. Press the power door unlock control three times.
5. Turn the ignition back to ON. The horn will chirp.
6. Press the unlock control, then press the lock control.
The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated.
7. Turn the ignition to OFF. The horn will chirp once to confirm the procedure is complete.
It happens a lot for the Tiburon apparently....what you have to do is put the key in the ignition whilst the horn is going nuts, turn the key to the "on" position and wait a minute or so for the horn to stop blowing. Then press the "unlock" button on the fob until you see the turn signals flash. try turning the key over and see if it will start up. If it doesn't, try again, same thing only turn the key all the way off and try starting as normal again. I can't remember if it's the "unlock" or "lock" button you're supposed to press, but one of them does it. Test it while in the car and see if it locks when you hit lock on the fob.....oh, and also make sure all the doors are shut while you are doing this. It recalibrates the fob to the car's computer and resets your security system and keyless entry.
The fob is infamous for its battery life. It gets drained so quickly that there happens to be a little later when the fob is very close to the door lock, ignition & unnecessary triggers the alarm due to low reception as the battery of the fobs discharges very fast, depending on the model, which has a certain virtual sheild(STARTRECK type) which is triggered by the fobs strength of the signal(radi waves).
Why not try a new set of batteries for your fob?? .................................sodeep
if its a factory alarm you put the key in and quickly turn the key on and of i cant remember if its 8 or 9 times but the horn will chirp then you push the lock and unlock on the fob the locks should respond then turn key off and your done. note that if you have more than one fob you have to press lock and unlock on all of them before you turn the key off and i believe you only have about fifteen seconds to do so if not let me know i will look it up at work
1. used the key to start the car...then turned it off
2. put the key in the driver door (door closed)
3. pressed the lock button on the key fob once
4. turned the key to lock the door.
This is basically the steps in the owners manual, but the car must be started with the key first, and the key must be in the door lock before pressing the lock button.
get in your car close door hit the unlock button then put key in the ignition cycle the key from off to on (STOP BEFORE START POSITION) cycle key off to on 7 times after the 7th trime the doors should lock the unlock automatically that means u are in trainning mode hit the unlock button on key fob. the key fob should now work if it doesn't then try changing batt
×