SOURCE: 2005 350z headlight upgrade to 08 xenon headlights
i have the solution. What you need is the headlight adapter plugs for the 08 xenons. you can wire up the 08 xenons exactly the same just follow the wiring diagram in the haynes manual for the headlights. Then you can just plug it right in. as far as the bumper goes it should be the same installing the bumper. i dont know if you will need to dremel at all to get the xenons inside the bumper. but as far as wiring goes just follow the diagram in the haynes or chiltans manual.
SOURCE: replacing front bumper on 1999 buick regal
7/16th or 10mm Sheetmetal nuts All over Behind the Bumper Thak Bumper off first
SOURCE: Bumper cover removal
It is a little more complicated than that. There are two nuts below the headlight assemblies in the engine compartment. You will need to remove the battery and overflow bottle to get at the one on the passenger side. Remove the turn signals in the bumper, then there are 2 or 3 bolts holding a mounting bracket behind the each of the turn signals. There are a number of bolts with washer heads and reatiners on the underside of the bumper as the previous responder indicated.
SOURCE: problem with hid on 2008 dodge ram 2500
Not too much amperage. HID lights use less amps. Duh. The circuit is showing a failure in the HID kit from not enough amps so it turns off. You need to add a resistor.
SOURCE: How to replace front wheel bearing on a 2002 Dodge 1500
You take off the right tire. You have take all the bolts out from underneath the
58 views
Usually answered in minutes!
×