Probably bad socket or ground. If both brake lights are blowing then replace brake switch.
Early bulb failure is caused by 1) high voltage or 2) bad ground connections, 3) excessive vibration, 4) corrosion inside the bulb connector
SOURCE: i have a 2006 jeep liberty and three lights are staying lit and
You need to take the jeep to a dealer or a good mechanic who can retreive the codes out of the computer. You may have a module problem but I will not guess without knowing the codes.
SOURCE: rear brake light keeps blowing out on 2004 jeep liberty
you need to find the intermittent short.
SOURCE: 2005 jeep liberty brake lights will not work. I
brake pedal switch, get a wire, unplug plug, bridge circuit and check lights.
plug and switch is high up on the brake pedal not normally easy to get to.
SOURCE: I have a 2008 Jeep Liberty sport it has 39600 back-up lights not
If you have tested fuses and bulbs with test light,and they check out,
the next step is to put you jeep in reverse with the key on,and use your test light to probe the wires before they enter the bulb sockets for power,if you have power replace sockets,if not check to make sure wires are still connected to back up light switch on trans,if you find no problem there,replace the switch
Testimonial: "Thank you for the info on my jeep. I brought it to my mechanic and he could not find where the new switch goes.I will bring it to the dealer."
SOURCE: i drive a jeep liberty renegade 2005 model break and tail lights
check brake switch under brake pedal... if not working change it..
249 views
Usually answered in minutes!
×