SOURCE: On Chrysler Town and Country van keys were locked in the car and
does this van have factory theft device? if so you may have to reset to get the ramp working
SOURCE: clunking noise when i go over bumps
have it put on a lift and the shocks and struts checked, they may be loose or defective.
SOURCE: CHRYSLER town and country mini van turn signal/flasher
I have a 2005 Chrysler T&C. The turn signal would not work at all or activate incorrect side. The switch is easy to remove as described by dukecityman.
Once the switch is of, it has four screws holding it together.I took this apart to find that there was a circuit-board which was contaminated with dirt. wiped it of, put it back together, working fine.
If you take it apart use caution. there are parts on the "top" which will fall out. ( they go right back in) The circuit-board is on the "bottom" half. You really only need to take this part off. (less moving parts)
Your going to replace it anyway, whats the harm?
SOURCE: ESP/BAS warning light on. went
Hi, these systems are all linked together. Most commonly, one of the wheel speed sensors is not reading or is reading incorrectly. This can also occur on slippery surfaces where one or more wheel slides enough to cause the sensor to drop the signal, but not enough to meet criteria for an abs or esp episode. If the light comes back every time you turn on the ignition, there is a deeper problem.
The system has detected a fault in the electronic stability program - brake assist system. You have an electrical connection at the rear wheels secured to the inside of the brake area and are viewable from under the vehicle. It is a small wire harness running to each wheel. Grab the connector and wiggle it around, and make sure they are tight. Due to the connector being mounted low to the ground, sometimes they become dirty or corroded, not making contact. Do this on both sides and see if the lights turn off.
If the light does not turn off, you have to replace dynamics sensor, which is mounted UNDERNEATH the center console in the car. There is a "lost communication to dynamics sensor" and "low voltage to dynamics sensor supply"..
449 views
Usually answered in minutes!
×