SOURCE: car won"t start..acts like the battery is dead .
possibly the alternator. or even a bad connection on one of the wires
SOURCE: car wont start
I noticed you replace the crankshaft sensor, but not the CAMshaft sensor.
The Ignition module takes the input of both sensors to tell the coil when to energize.
This sensor should come up as an error code when you attach a obd reader.
Even if your light is not on - there may be a code. If it is not your vehicle originally, some people pull the bulb!
SOURCE: 1990 corvette won't start -
Gm vehicles have had a ton of problems with the antitheft systems. When will turn the starter off when not functioning properly. http://vatspasslockpasskeysecurityhelp.yolasite.com/
SOURCE: won't start. Battery has full charge and fuses good
Check starter relay fuse and fuel pump fuse inside under hood fuse box. Take out those 2 fuses (they are the same size) and bend the 4 tabs outward a little bit, then re-insert. This will help the fuse prongs make contact inside fuse box.
Instructions
Turn your ignition key to the accessory position when the lights and
radio come on (before starting the car).
Press and hold the "Trip" button on the instrument panel until
the red light comes on.
Press the "Trip" button a second time and hold until
"Reset" appears.
Press the "Trip" button a third time. The computer is now
reset
512 views
Usually answered in minutes!
×