Car key fob want lock or unlock doors no power ford edge 2016

Michael Thomas

• 3056 Answers
• Posted on Mar 08, 2009

SOURCE: key fob will not lock or unlock doors on 06 Sonata

Hi there
i have the same problem but mine is the sensor that is under the dash that is faulty so i had them disable it untill i can get a part that they need to order so i would have your dealer check the sensor .. if it is under warranty they will replace it for free

SOURCE: Car will not unlock.

To get inside the car .... Use the key in the lock cylinder, unlock the drivers door to get inside. You shouldn't have to reprogram the fob unless it or the keyless module was changed. There may be a blown fuse that supplies the keyless control module (check the owners manual for location). or wires that lead into the Drivers door may be damaged ... The keyless module is located inside the drivers door at the bottom behind the door panel ... do the unlock/lock and trunk release switches on the inside of the drivers door operate the locks and or trunk release? If so it is not the fuse ... and not the wires to it ... And it could be your BCM body control module, located in the dash board to right of your gas petal. Because the number entry keypad (code for that is on the inside of the right passenger trunk bracket arm) also doesn't work I assume it's not the key fobs themselves. Your 98 manual is correct for your car.

SOURCE: c240 mercedes key wont turn seems locked

I have a 2001 C240 with the same issue. I removed the positive battery cable from the battery and kept it off for 30 seconds then replaced it. Everything was reset and the key worked.

SOURCE: My Porsche Cayenne S Key fob no longer unlocks the Door

unlock the door then press the lock button on remote and hold down for 20/30 secs.manual does say hold button.....

SOURCE: key fob will not activate anything. can't

I too had this problem. I finally found out that my problem was the result of the metal contacts that touch the circuit board when you push the buttons had worn out. To correct my problem, I purchased a small pad that slides right inside the remote and fixes all the buttons. Since then, my remote has worked problem free for the past 3 months. The company that makes the pads is KEYLESSFIX. The following link will take you to the actual website:

http://www.keylessfix.com/keylessfixcom/

Please remember to rate my solution. Thanks!