While not impossible the car would simultaneously develop a handful of seemingly unconnected faults, none of which alone is likely to prevent the engine showing some signs of life.
Clearly the systems flagged in the codes must be checked after a thorough visual inspection but I feel it is doubtful whether any fault will be found and further checks will probably point an accusing finger at the engine management computer.
SOURCE: no running daytime running lights or side lights
i had a similar problem with my 97 a4 2.8. i changed my daytime running lights relay and it solved the problem. its located under the steering wheel behind the knee bolster
SOURCE: audi a4 2.8 quattro idle valve
there is no carburetor on these cars , the idle air control valve is an easy thing to change it is on the passenger side near the firewall on the back of the engine buy the new one so you know what it looks like it has a wire connector on top 2 bolts and a gasket behind it just unhook it unbolt it remove the old gasket install the new one with the new gasket and plug it in simple there is no sealer required
SOURCE: i want a user manaul for my audi a4 1.8l quattro
Here is a manual, but you have to purchase it:
http://shopping.msn.com/prices/audi-a4-service-manual-1-8l-turbo-2-8l-including-avant-and-quattro/itemid2373553/?itemtext=itemname:audi-a4-service-manual-1-8l-turbo-2-8l-including-avant-and-quattro
SOURCE: Code P0118 on Audi A4 - Related to Ignition Coil Problem?
Hi, the sensor on the engine (right at the rear end of the cylinder head) has two separate outputs. One drives the temperature gauge and the other provides data for the engine control unit. The output for the engine control unit is almost certainly faulty and the sensor will need to be replaced. It isn't an expensive item and's not time consuming to replace (1/2 hr) - so you could ask Audi to do it for you when they replace the ignition coils.
Hope that helps Matt..
SOURCE: How do you enter code to reset 1999 A4 Audi 2.8
IMPORTANT NOTE: You must have the security anti-theft code for yours Audi Concert radio from the car manufacturer! For Audi Concert Radio the sequence of programming is:
1. Push simultaneous "SCAN" and "RDS" keys until on the screen will appear "1000" displayed.
2. Release keys. No more push on "SCAN" and "RDS" keys because otherwise number "1000" will be considered as first safe code attempt.
3. By the #1 key you will set up the first safe code digit.
4. By the #2 key you will set up the second safe code digit. 5. By the #3 key you will set up the third safe code digit.
6. By the #4 key you will set up the four-th safe code digit.
7. Then push again simultaneous "SCAN" and "RDS" keys for confirm this safe code. On the screen will be displayed "SAFE" notice. Release keys! For few seconds a radio frequence will be displayed. The radio is now ready for use!
160 views
Usually answered in minutes!
×