You can't buy a fob and program it
SOURCE: antitheft problem
Something in your anti theft system has failed. The key,transceiver, or module. The only way to find out is to run a diag on that circuit. You will need special tester.
SOURCE: remote key fob won'tprogram
1-insert and remove key from ignition two times
2-close and open driver door two times
3-insert and remove key once from ign.
4-close and open drvr door twice
5-insert key into ign.,then close driver door
6-turn key to on (not start) then off, twice this is rewrite mode,have all remotes to reprogram it will clear any lost remotes.
7-remove key from ignition,the door locks should cycle twice.if not start over.it may take a few tries.
8-press lock/unlock together and hold for a second
9-release,and press lock on remote,the door locks will cycle
confirming program.continue to do other remotes you have,steps 8 and
9.if only one in possession,you are done. To end mode open door or insert key into ignition.
You'll need to follow the steps with no more than a 1-2 second delay between each step.. hope it works
SOURCE: How do I reset the anti- theft computer in a 1999
did you try to remove both battery cables for about 10 min or so ?? that may reset the comp and clear the problem
SOURCE: how do i reset the
The system reset any time the correct ignition key is turned to the run position or the door is locked and unlocked with the key, there is a sensor on the lock cylinder. If this is what you have done then already then the system have problem and you will need the dealer to scan it for fault codes. You may have a defective key transponder sensor in the ignition lock cylinder.
76 views
Usually answered in minutes!
×