Appears it's a conventional electronic ignition, so has it been regularly maintained. Plugs, wires, cap and rotor?
SOURCE: Location of EGR Valve
Found the info!!
This Dodge EGR valve is a certain kind of device that is mounted right on your intake manifold which controls the amount of exhaust gasses back into your engine.
On a 2005 Dakota with 4.7 liter engine (non-HO), the EGR valve is located near the intake manifold on the driver's side right up against the firewall. It's hard to spot as it sits lower than the intake manifold.
To change it, remove the electrical connector. There's a red tab that needs to be pushed to one side and then you have to squeeze down on a tab to get it free. Using a 13 mm socket, remove the bolt that you can see. I had to use a 3 inch wobble extention and then a 8 inch extension with a deep well socket to reach it with my 3/8 inch ratchet.
There's a second bolt that you can't see between the EGR valve and the firewall. With a little trial and error and a lot more luck, you can reach the hidden bolt with the 3 inch wobble extension and a 13 mm deep well socket. Attach the ratchet after the socket is on and remove. This one isn't easy and if there's any Dodge engineers reading this one, a couple of extra inches of clearance between the valve and the firewall wouldn't have killed you no matter what the cost accountants said.
With both bolts removed, you should be able to pull out the metal pipe that connects the manifold to the EGR valve out of the manifold (Pull to the right) and then you can lift the valve out.
For assembly, the metal pipe connecting the intake manifold the EGR valve has to be removed and reinstalled on the new valve. It's held on with 2 5/16th" bolts. You should put the rear bolt on tight, but leave the front bold loose for the reinstall as some adjustment is necessary to get it put back together and the rear is a pain to tighten when installed.
Line up the bolts that attach the valve and get the rear 13 mm bolt (The one you couldn't see on disassembly) started. Do not start the other 13 mm bolt as you'll need to pivot the valve and pipe to the left in order to reinsert the pipe into the intake manifold. Once the pipe is in the intake manifold. Start the other 13 mm bolt and tighten both 13 mm bolts and then the 5/16" bolts holding the pipe onto the valve. Reinstall the electrical connection.
Please don't forget to rate!!!!
SOURCE: why does my 1998 gmc truck backfire and stutter sometimes stall when driving
my friend the car backfires if its runing lean ( insufficient fuel ) or runing rich ( insufficient oxygen ) this mostly in carbourated cars would make incomplete compustion . in engine with fuel injuction there may be a leak in the intake valve that makes the fuel to burn in the exhaust pipe . so check for leak asap
SOURCE: 98 dodge dakota starting to stall while driving
sounds like maf is acting up. 1st sensor coming out of air cleaner
SOURCE: Dodge Dakota shuts off without warning
You may have a bad cam or crank sensor this enginge needs both to run is the check engine light on?
SOURCE: loss of oil pressure 1995 dodge dakota 4 wheel
sounds like you may have a defective oil pressure sending unit.
436 views
Usually answered in minutes!
×