A camshaft is internal to an engine so I would suspect it might be in there. But it could be other places.I would suggest learning how to use search engines , then search for 2000 kia rondo engine parts. It will amaze you as what you can find.
SOURCE: TPMS of KIA Rondo 2007
the only solution on that is to replace it. it is'nt be recalibrated. the instruction are in the operating manual that is sent with the car.
This may still be under factory warranty.
My first guess would be the cooling fan stopped working.
SOURCE: why does fuel sensor not work correctly after replacing fuel pump on 2009 kia rondo?
you must mean the fuel gauge? is dead? just a hint here.
wire /connector left loose.
when replacing any fuel pump check the 2 pins on the level sender
it will read 10 to 200 Ohms about 10 is full, and 200 or bit higher is empty, if the sender reads INFINITY. the sender is bad.
or is unplugged in the tank.
the sender is just a wire wound variable resistor.
a pot or correct name is a rheostat. (electronics, true names)
on car, its a FUEL level SENDER.
double posted.
SOURCE: where is the oil pressure sensor located on a 2007 kia rondo
Check around the filter housing or on the side of the engine.
SOURCE: where is the camshaft position/bank 1 located on a 2007 kia rondo?
Parts stores have parts locator charts which may show this
121 views
Usually answered in minutes!
×