Location and replacement of fuel filter for 1999 KIA sportage

SOURCE: 1996 fuel filter location

its on the left side of the engine under the intake..its a bit of a squeeze but it can be removed without removing other pieces

SOURCE: I have a 2002 Kia Sportage - idle slow when stopping at lights

Even though the fuel filter and pump are easy to replace, I would start with the IAC sensor first. It is easier to get to and is cheaper than the other two if you can find one at a wrecking yard (should be around $20). This sensor is the Idle Air Control sensor, and the computer decides how much throttle to give at idle from the readings of the sensor. If it is bad your car will idle poorly or not at all.

You can verify this two simple ways:

1. Disconnect the sensor completely and see if anything changes. If you get the same issue, then it's probably the sensor. If different then it could be fuel delivery.

2. With it all hooked up; try throttling the engine yourself at 1000-1200 rpm and see if it is smooth. If it is then it is probably the sensor. If not then could be the fuel delivery.

The sensor is under the silver and black, plastic KIA cover over the engine (4 small nuts to remove), and is center above the engine on the front side of the intake pipe.



The part looks like this:


If it seems to still be fuel delivery, the filter is (facing the engine from the front of the car) down to the left and toward the back attached to the fender well (Just to the right of and below the battery)

Greg Bernett

• 2993 Answers
• Posted on Jul 26, 2009

SOURCE: 1999 kia sportage timing marks

Crankshaft match marks


Align marks on timing belt pulley and pump body.

Camshaft pulley alignment marks

1. Align marks on camshaft pulleys with alignment marks on seal plate.
2. Install timing belt. NOTE: No looseness should exist on the tension side and at the camshaft pulleys.
   
3. Loosen tensioner lock bolt.
4. Turn crankshaft 2 revolutions in direction of rotation and check that timing marks are still in alignment.
5. Tighten timing belt tension lock bolt to 27-38 ft lb (32-52 Nm).
6. Apply a force of 22 lbs to timing belt between camshaft sprockets.
7. Belt deflection should measure 0.30-0.33 in (7.5-8.5 mm)
8. NOTE: Replace tensioner spring if timing belt deflection is excessive.

1. Install lower timing belt cover.
2. Install upper timing belt cover.
3. Install power steering drive belt and adjust belt tension.
4. Install fan pulley.
5. Install generator drive belt and adjust belt tension.
6. Install A/C drive belt and adjust belt tension.
7. Install splash guard.
8. Install fan and fan shroud.
9. Install 4 fan bolts. Tighten to 24 ft lb (33 Nm).
10. Install fan shroud mounting bolts.
11. Install fresh air duct.
12. Connect hose to resonance chamber.
13. Connect battery negative cable.

SOURCE: where is fuel filter located in a kia sportage

The fuel filter is bolted to the frame rail below right of the battery. It is cylinder shaped and has a fuel line at each end.
Procedure for removing it:
Find the fuel tank access plate under the rear seat. With the engine idling disconnect the fuel pump wiring harness and let the engine stall. This relieves the fuel pressure.
The lines on the fuel filter itself are "quick connect" fittings. Depress the tabs on the fuel line and push TOWARDS the filter. The line should pop off. It's difficult to depress the tabs and you CAN use a pair of pliers but be careful or you'll damage the fitting.
Reverse to install new filter. Reconnect fuel pump, start the engine, and check for leaks.

SOURCE: where is fuel filter on Kia 2001 sportage located?

Hi there,

Here is the exploded view of your fuel system, fuel filters are encircled..


Regards,
Jeep Brainy