Where is the evap pressure sensor on a 2006 scion C?

Where is the fuel pressure sensor located?

The sensor is part of the fuel pump assembly and is mounted on top of the tank or inside the tank. It's part of the evaporative emissions system (commonly referred to as "EVAP") and reads pressure in the fuel system to detect evaporative leaks, such as a loose or faulty gas cap.

Fuel Tank Pressure Sensor ' Cars.com

https://dashboardsymbols.com/2019/06/scion-warning-lights-and-symbols/

https://dashboardsymbols.com/2010/09/tire-pressure-monitoring-system/

the EVAP prerssure sensor

A 6 hr dealer job. Most of the dash needs to come apart and then split the evap core case. Don't forget to release the pressure.

If you need further help, reach me via phone at https://www.6ya.com/expert/chris_b82b45c59bcf133d

P0453 means EVAP emission pressure sensor high input. Possible causes:
- Faulty Evaporative Emission System (EVAP) Pressure sensor
- Evaporative Emission System (EVAP) Pressure sensor harness is open or shorted
- Evaporative Emission System (EVAP) Pressure sensor circuit poor electrical connection.
Code p0701 means Transmission control system range/performance. Possible causes:
- Open or short transmission control system circuit
- Poor transmission control system electrical connection
- Check powers and grounds to Transmission Control Module (TCM)

Did they replace the tire pressure sensor kits?

You have a fule sensor in your file tank and it is this that he has said is faulty
Regards
Adam

POSSIBLE CAUSE EVAP CANISTER PURGE VALVE.FAULTY EVAP PRESSURE SENSOR.CHECK ALL EVAP SYSTEM.HOSES AND ELECTRICAL CONNECTIONS.

front is as same as gm, 2 on caliper do not forget to press caliper pistons back into themselves, then just take pads out and replace then, install and start car and press on brake to bring pressure back into caliper