Bolts, Clutch Cover-2.5L . . . . 28 N·m (250 in. lbs.)
Bolts, Clutch Cover-5/16 Bolt . . 23 N·m (17 ft. lbs.)
Bolts, Clutch Cover-3/8 Bolt . . . 41 N·m (30 ft. lbs.)
Bolts, Clutch Housing-NV1500 . 38 N·m (28 ft. lbs.)
Screws, Master Cylinder Reservoir . . 5 N·m (40 in. lbs.)
Nuts, Master Cylinder . . . . . . . 54 N·m (40 ft. lbs.)
Nuts, Slave Cylinder . . . . . . . . 23 N·m (200 in.lbs.)
Bolt, Dust Shield . . . . . . . . . . 12 N·m (105 in. lbs.)
Bolts, Flywheel-2.5L . . . . . . . . . 95 N·m (70 ft. lbs.)
Bolts, Flywheel-3.9/5.2L . . . . . . 75 N·m (55 ft. lbs.)
First crack your knuckles one .More ok.
SOURCE: What are the torque specs for 1990 dodge dakota front suspension.
call carquest or other parts house and ask them for the torque specs or a front end alignment shop.
SOURCE: torque spec for king nut on front spindle of 1999
Unsure as to what you are calling the King nut but here are the torque specs for your front end.
Steering Gear-To-Cradle Bolt...........135 ft pnds
Steering Gear-To-Crossmember Bolt (Dakota 2 WD)..........190 ft pnds
Suspension Cradle Plate To-Cradle Attaching Bolt..............123 ft pnds
Tie Rod End-To-Steering Knuckle Nut Dakota (2WD) .............65 ft pnds
Tie Rod Lock Nut.....................55 ft pnds
SOURCE: What's the outer tie rod end torque specs for 2000 Dodge Dakota sport ?
this was copied off of the following link. should be same torque requirments-
this is off a 2004 manual,which should be real close if not exact
INSTALLATION
1. Align reference marks and install pitman arm.
2. Install the lock washer and retaining nut on the pitman
shaft and tighten nut to 251 N·m (185 ft. lbs.).
3. Install the drag link (1) to the pitman arm (5). Install
the nut (4) and tighten to 54 N·m (40 ft. lbs.) Then
an additional 90°.
4. Remove the supports and lower the vehicle to the
surface. Center steering wheel> and adjust toe,
(Refer to 2 - SUSPENSION/WHEEL ALIGNMENT -
STANDARD PROCEDURE).
5. After adjustment tighten tie rod adjustment sleeve
clamp> bolts to 61 N·m (45 ft. lbs.).
NOTE: Position the clamp on the sleeve so retaining
bolt is located on the bottom side of the
sleeve
got it from here -
Tie rod end torque spec DodgeTalk Dodge Car Forums Dodge Truck Forums and...
SOURCE: Whats the torque specs on a valve cover bolts on a 1999 dodge dakota sport 3.9l eng
It is about 9 ft lbs, snug up all bolts, then torque them. do a cross pattern, to get the cover flat.if not there may be a leak. God-Bless!
1,127 views
Usually answered in minutes!
×