Just noticed this morning that passenger side brake light doesn't work when brake pedal is pressed, all other lights work including brake light on driver side, all fuses are good.
Pull the tail lamp assembly passenger side an disconnect the 5 pin connector at the back .With a test light or volt ohmmeter test for battery voltage at pin B lite blue wire , while someone pushes the brake pedal . If you have battery volt , replace the taillamp assembly . know internal problems in the tail lamp assembly .
Possible you need to replace light bulb.
1. Defective wiring
2. Defective socket
SOURCE: 1991 Honda Accord brake light probelm.
Check the prones inside the connector that you plug into the brake light module. You may have to squeeze, wiggle, tilt each one to see which one is not connecting all that good. I know it may sound confusing. I tried to explain the best of I could.
SOURCE: Emergency Flashers totally out, Rear lights malfunctioning
Check the ground on the passenger side rear lights, it's likely bad. As for the hazards, sounds like a bad flasher or fuse.
SOURCE: driver side mirror 2004 Pontiac Grand Am
On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door
SOURCE: 2002 Jeep Grand Cherokee - Brake lights not
The problem is that the tail lights, light bulbs get too hot and melt the plastic where the bulb socket goes into the lens assembly. On the lens assembly you will see one to three metal tabs where the socket fits into. Lift up the tab a little bit with a screw driver and place a small amount of either metal or plastic underneath the tab so it will get a good connection. It will fix the problem.
161 views
Usually answered in minutes!
×