It`s a 2000 mazda mpv also i can not find the red button for a reset.help
You'll need a fuel pressure tester, there's a shrader valve under the throttle body that you attach the tester to. When your tester is on crank it a few times and check the gauge. I'm pretty sure it should read 55-65psi.
Swap the fuel pump relay with another that is identical if there's no pressure and retest. Most likely it's the pump if there's no pressure.
Testimonial: "thanks i will try it"
SOURCE: water pump replacement in a 2002 Mazda MPV
The reason is the water pump is driven off the timing belt, extra parts and allot more labor. No the eng does not have to be removed, labor time around 4 hours, parts about, about $125 US for parts, if it is a dealer add $75 US
SOURCE: can't find reset switch for fuel pump on mazda mpv
It is typically located in the rear of the vehicle in one of the side compartments. It has a red button on it. I would also check the fuel pump fuse, and relay.
SOURCE: mazda mpv 2000 water pump
It' on the driver's side. Under that little belt cover just to the left[looking at it] of the batteryand foward of the intact plumbing.
SOURCE: how do I replace alternator in mazda mpv 2000?
Typically an alternator is an easy fix. It requires removal of the belt from the engine running it, and a few bolts that attach it to the engine.
Because of the engineering with the 2000 mpv, it is a very difficult fix, and one that requires removal of the transaxle and exhaust manifold, as well as removal of the lower engine mounts. It will take a qualified Mazda mechanic 3.5 hours to do the fix - you can (at least) triple that amount of time as a DIY project (assuming you have the right tools).
SOURCE: My 2000 Mazda MPV heater fan works for 4 not for 1
You need to replace the blower motor resistor,it's in the heater box.Number 4 bypasses the resistor and all the other speeds go through it so it's the most likely problem.
42 views
Usually answered in minutes!
×