Oil filter tarago

There are videos on you tube for diagnosing vehicle no start problems ! Rather then just replacing parts . Testing for spark and fuel pressure and engine compression . Timing chain problems etc... My advice to you would be take your vehicle to a qualified repair shop . Save yourself some money . You spent how much already ? i changed filters n spark plugs n pumps still no start !!!!!!!

Most likely the oil pressure sensor is failing or connection to it is poor.

old vehicles like this are normally under the vehicle by the fuel tank

Parts houses have a filter chart for determining the filter number. I believe that a #16 fram filter is used on yours but different "cross-over" numbers from other companies will also fit. Your vehicle capacity is four quarts with filter.

possibly the oil pressure sending unit- looks like a small spark plug screwed into the engine with one wire going to it

cooler located on passenger side front. Remove oil filter and find 10-15 10mm bolts. Cooler is sandwiched between filter head plate and the block, two gaskets, not much trouble to fix. Good luck...

Make sure the old filter gasket is not stuck on the filter housing. sometimes the old filter gasket comes off the old filter and when you put on the new one it will leak.

theres 3 things ur emisans fail on 1 spark plugs 2 air filters need changing 3fuil filter so yes a full service should do it change ur oil fuil filter air filter oil filter and oil

is it an ex?
is it a bad leak?
it could be 2 things
1) oil pressure sending unit above the filter
2) "o" ring between the oil cooler and block on ex models only. the oil cooler is between the filter and block with 2 coolant hoses attached to it. also might be the oil filter. i replace alot of sending units and oil cooler o rings.

try tightening the oil filter turn by hand clockwise as tight as you can failing that replace the filter