I have a 2013 lancer and the power windows are not working. When I press the button the doors lock. Any ideas on the problem

SOURCE: 2004 tahoe

make sure than you have not split any fluids on the passenger front door most of the times is where the module to control the windows and doors is located, try by unpluging the batterie and the after a minute plug it back and see what happend but if any of your ft doors have been split with liquid or rain has gone inside then most likelly the module got moisture and not working

SOURCE: 2001 Saab 9-5 Power Door Lock problem

Does the key still pop the trunk/hatch? That would also indicate whether or not it was the key remote. If that function works it's probably nothing on the car (i.e. "receiver") end.

There is a very good SAAB forum that would likely be the best place to find out if somebody has has this issue before and what they have done: www.saabcentral.com

SOURCE: 1998 Jeep Cherokee Internal locks and power locks Not working.

Open the door panels and lube all of your lock mechanisms. They tend to get stuck and it harms the locking motor. After I lube mine up, they freely move. Just spray some lithium grease and manually lock and unlock the door with the rocker until it moves very easily. You'll probably have to do this once a year like I do.

SOURCE: power windows and power locks wont work

Check your fuses first. Then check for power at the switches, and power from the switches to the respective solenoid and motor. Most likely it's fuses. Also check where the wiring runs through the door into the car for bare spots in the wiring that might have blown the fuses.

SOURCE: power door lock doesnt work properly, it unlocks but wont lock

Hello, I had a similar problem. I checked the fuses dr unlck 10amp, dr lock 20amp, both fine. However, I finally had no choice and checked all other fuses and the 15 amp fuse labeled "CTSY" was bad! So, check that fuse. If a similar problem has happend to you, it could be all you need.
lol