On MANY Mercedes you have to use a Computer with Mercedes software to activate electrical components. One instance was when I changes a window regulator and motor on the drivers door and it would not work and turned on the 'check engine' light. I connected my 'Mercedes Diagnostic Computer' and followed the reset procedure, reset the check engine light and everything worked. You may have the same issue. The cluster component may have to be reset using a Diagnostic Computer.
SOURCE: 1999 S10 battery light stays on
could have a loose wire did you check your alternators output voltage? if it's 13 to 14 drive it, as these have internally mounted voltage regulators
SOURCE: 2004 e500 mercedes trans problem code-2767 need
Hi,
The code P2767 definition is ,
Transmission input shaft speed sensor?turbine shaft (TSS)sensor B no signal..
Now in English it means the speed sensor is either faulty or bad connection,I would suspect the sensor, but worth getting checked by a transmission specialist,
Darren DCS
SOURCE: dead battery mercedes 03 e320
theres a manual key in your romote key . all you need to do is put your key face down( pacni red button on the batton) you see a little botton that you puch to the side and pull yhe metal out.
SOURCE: 2004 Impala battery goes dead sporatically.
try removing radio, ive had 3 impalas that drove me crazy! daignosing, they would drain the battery if car sat a weak,ending up being the radio shorting inside, dont know if thats your problem but i would start there, dont remove fuse have to remove the radio! hope this helps.
SOURCE: 2003 mercedes e500 brake lining light in
If the brake wear light on you can't reset the light without replace brake pads and sensors inside the pads must replace both after replace it will off automatically
124 views
Usually answered in minutes!
×