Turn signal switch may be worn out .
Does that mean the whole pc. with 2 levers under the steering wheel? Or something else?
I'll check a wiring and fuse schematic if I can get it to pull up online. The program I have is locking up on me . A fuse or wiring issue is possible . Rock Auto lists turn signal switches as separate as well as both levers . From $25 to $70 according to the options . Used may be worn out too even if you can find one . If my program unlocks I will see about the fuses and post back .
×
SOURCE: Turn signals do not work at all.
Hi iveybunch
please check your thermal flasher ( the gizmo the makes the turn signals work)
It's probably in the fuse panel in the dash. Usually just to the left of where the drivers knee is located
It's a little silver can. You can get one aat any auto parts store
Hope this helps. Loringh PS please leave a rating if appropriate Thanks
SOURCE: Does a broken timing belt permanently damage a Mercury Tracer
depends on the Engine in the car.
1.9L SOHC (SEFI on Valve Cover)engine, no, they are non-interferance engines, put a new timing belt on it and go.
1.8 DOHC engine, yes, it will destroy the valves, head, pistons, and if really bad, the block too. These engines are interferance engines, where the valves just barely miss the piston as it comes up, and when the belt breaks it will hit the valves and destroy the engine.
SOURCE: LEFT TURN SIGNAL LTS STAYING ON AS WELL AS IND.
Yep, happened to me as well. Same side and everything. Turns out they have to replace a component on the BCM by replacing the BCM itself. Runs about $1000 - $1200 at the dealer. Tough luck but there is a chance it is still covered under your warranty.
SOURCE: my 1997 mercury sable signal lights dont work
The flasher module is responsible for the flashing of the turn signals and hazards. this device will fail overtime. you will need to replace this failed module asap. Replacing the flasher will restore the signal functions in this vehicle. (Check the bulbs before replacing the flasher)
SOURCE: turn signal and hazard do not work
please have the bulbs and wiring checked then if all are ok! the problem would be either the swtch or the flasher unit!!!!!!!
41 views
Usually answered in minutes!
×