Cars & Trucks Logo

Related Topics:

n
nathan s Posted on Nov 18, 2019
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

99 Subaru outback has no reverse. Will go into reverse but does nothing

1 Answer

Eugene Davis

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 200 Answers
  • Posted on Nov 18, 2019
Eugene Davis
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Aug 26, 2012
Answers
200
Questions
43
Helped
42583
Points
596

Could be a sensor ,but your best bet is to have car scanned for transmission codes

5 Related Answers

Anonymous

  • 11 Answers
  • Posted on May 11, 2009

SOURCE: I have a 99 subaru legacy outback trans slip

cheak your fluid level in your transmission as if it is low it wont go into gear properly you will move it from park or neutral to a gear it can take a while before it will kick into gear if you top up the fluid that should fix the problem if it still does it after this take it to a tranmission specalist and have it serviced as the bands may be streched

Ad

Anonymous

  • 15935 Answers
  • Posted on May 23, 2009

SOURCE: needdrive belt diagram for Subaru outback 3.0

8c0dd6e.gif
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Anonymous

  • 100 Answers
  • Posted on May 28, 2009

SOURCE: 1997 subaru outback make clicking noise on in reverse. Also, sometimes when the car is turned off, the car lurches a bit

does it click while reversing straight or while turning? Sounds like a stick shift. Lunging probably due to e-brake needing adjustment(if stick shift). If your car only clicks while turning in reverse you need new front axles and can probably drive that way for a while

Anonymous

  • 58 Answers
  • Posted on Jan 02, 2010

SOURCE: 1996 Subaru Outback Engine Code P0170

P0170 Fuel Trim Malfunction (Bank 1), could be fuel filter, mass air sensor, or low fuel pressure.

Anonymous

  • 176 Answers
  • Posted on Feb 17, 2010

SOURCE: abs light stays on my 99 subaru outback. what

you have to go to your local garage and have the car computer scanned

this will tell you which wheel sensor is not working properly, or abs module

Testimonial: "thanks for the help "

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

How do I fix my 99 Subaru Legacy outback?

no code given vehicle in limp mode look up your code and on some sites gives info as to correcting problem if above what you can do bring to a tranny place
0helpful
1answer
0helpful
1answer

2003 Subaru outback h6 3.0. Starts fine, when I shift into reverse or drive I get a loud grinding noise

Is your 2003 Subaru Outback automatic or manual transmission?
If it is automatic, then your transmission sounds like it's malfunctioning into the reverse gear as it is not aligning properly.
If it is manual, then your transmission sounds like it may have a bad clutch or bad reverse gear.
Either solution is not cheap. Good luck.
0helpful
2answers

Blinking parking lights on my '97 subaru outback that is draining the battery

i have found on my 99 outback that if you disconnect the battery this happens usually all you have to do is use you remote door lock and unlock button a couple of times
0helpful
1answer

Water in front blinker 99 subaru outback

After removing housing there are 2 clips top and bottom that release the lens. Make sure and use sealant when reinstalling. Good luck and have a great day.
1helpful
1answer

'99 subaru legacy gets 2 flashes from LED and

try opening door and holding unlock button ,it sounds like its in valet mode
0helpful
1answer

1997 subaru outback make clicking noise on in reverse. Also, sometimes when the car is turned off, the car lurches a bit

does it click while reversing straight or while turning? Sounds like a stick shift. Lunging probably due to e-brake needing adjustment(if stick shift). If your car only clicks while turning in reverse you need new front axles and can probably drive that way for a while
0helpful
1answer

Binding of rear end when turning and abs light on. subaru 97 outback.Clutch pack or sensors or what?Grabbing in forward and reverse when turning sharp.

just a suggestion mate, it might be your universel joint, a mate of mine has experienced a very similar issue as you are experincing now and the knucle had some how renervated its location and his rear-end was also binding up forward, reverse turning only, i could be wrong, but that was what happened in his case thats all, he had subaru GT250, 
0helpful
1answer

Whining noise in reverse

its a normal sound nothing to worry about every car does it that is front wheel drive
Not finding what you are looking for?

300 views

Ask a Question

Usually answered in minutes!

Top Subaru Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Oliver Street

Level 2 Expert

73 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...