The service and repair manual with diagram will provide you step by step help to locate and fix the problem on your own easily and you will get the manual from the given link https://toolsnyou.com/
If the squeaking noise is still an issue please write back. Try writing back with more details. I'm not sure from your description if the Squeal, Road Speed and Smoke are related. You could be talking about your brakes. If a brake caliper was seized or the parking brake was stuck in the Applied position. This could cause all of your above symptoms. If this is the best you can do to describe the problems, do not worry. Please bring it to a shop or dealership for diagnostics. You can not continue to drive this car as is. The symptoms you have described make this car unsafe to drive. If there is anything new to add please feel free to write back.
SOURCE: crankshaft sensor for 2004 kia sorento
The above information about the sensor being located at the top of the motor to the passenger side of center is bogus. That is only the pig tail plug in. The actual sensor pig tail continues down below, underneath the plastic lower timing belt cover, on the front of the motor, just above the crankshaft timing gear.
It is a very involved process of removing and replacing. You will have to remove all of the belts, the front timing belt covers, (upper and lower). You will also have to remove the front bracket that is mounted to the front of the block, which serves as the mount for the power steering pump, the alternator and the A/C compressor.You will also have to remove the crankshaft pulley. You cannot remove the plastic lower timing belt cover unless you remove all of these things first. The sensor is located underneath the lower cover. It has two bolts that hold it in place. You will have to remove these two bolts.
The crankshaft pulling bolt is a right handed thread and loosens by turning counter clockwise. The pulley will slip off but is a very tight fit. Do not try to turn it while removing it as there is a small pin that keeps it aligned to one position. Use a small ball pine hammer to tap it loose.
It is also a good idea to remove the electric cooling fan shroud that is mounted to the inside side of the radiator and the radiator hoses to give yourself more room to work. It has only two bolts at the top holding it in place. And then slips into two retaining clips at the bottom. Lifting it will pull it out of these retaining clips.
When you remove the small bypass hose located at the top of the radiator , to the passenger side, be careful not to break off the small nipple protruding out of the radiator tank. It is plastic and will break easily if you try to pull the rubber bypass hose from it. This will have to be taken to a radiator shop to have repaired if you accidentally break this off. Be sure to carefully loosen the hose from this nipple before trying to pull it off.
And one more thing, if you go to that much trouble to replace this sensor, it is a good idea to go ahead and replace the timing belt as well. It is a maintenance item and you will have to go through the same process to replace it as well. Do it once and do it all.
I hope this helps.
SOURCE: I am changing the spark plugs on my 2004 Kia sorento
Be careful there.. If you remove the Throttle Position Sensor TPS or the throttle Cable, the engine light will come on because there is a certain setting that needs to be done to ensure accurate emission control.
SOURCE: reset check engine light in a 2004 Kia Sorento
usually you can reset a check engine light buy disconnecting the battery for about 30 minutes.
SOURCE: does the kia sorento 2.5 crdi xe have a timing on a 2004 plate
THE KIA SORENTO HAS 3.3 AND 3.8 ENGINES THEY HAVE TIMING CHAINS.THE KIA 2.4 ENGINES HAS TIMING BELT GUIDE PLATE.
70 views
Usually answered in minutes!
×