SOURCE: Starter in a 1992 GMC Sonoma 4.3 v6
bottom rear of engine on the passenger side, the starter is serviced from under the car. it is held to the engine block with two bolts, then u must remove the battery cable and starter solenoid wiring as well, always disconnect the battery before doing any work on the starter.
SOURCE: I have a 2000 gmc sonoma and while driving down
Probably the CV joint. When you put it in 4x4 that puts extra torque on it so it wont vibrate so much.
SOURCE: how do I install starter for 2000 GMC Sonoma
e
Removal & Installation
2-Wheel Drive - 2.2L Engine
To install:
Negative battery cable
Front exhaust pipe, if necessary for access
Starter heat shield, if equipped
Brace rod from the front of the engine and the bell housing
Drivers side wheel to access the starter motor wires and the
starter motor attaching bracket-to-engine bolt through the opening in
the wheel well
Wires from the starter solenoid
Attaching bracket-to-engine mount bolt
Starter-to-engine block bolts. When removing the last bolt, be
sure to support the starter to keep it from falling and possibly
injuring you.
Starter and shims (if equipped) from the vehicle
Bracket from the starter assembly, if equipped
Fig. Starter motor and related components - 2.2L engine
Bracket to the starter, if removed. Tighten the bracket nuts to 97 inch lbs. (11 Nm).
Starter and shims (if equipped) into position in the vehicle and thread one of the retaining bolts to hold it in position.
Bracket-to-engine mount bolt (loosely), if equipped
Starter mounting bolt, then tighten all mounting fasteners to 32 ft. lbs. (43 Nm)
Wiring to the solenoid
Brace rod and tighten the retainers
Front exhaust pipe and tighten the fasteners, if removed
Starter heat shield, if equipped
Driver-s side wheel, if removed
Negative battery cable
Hope helped with this (remember rated this help) Good luck.
570 views
Usually answered in minutes!
×