Hey Shirley,
here is the sensor:
https://www.rockauto.com/en/catalog/kia,2011,sorento,2.4l+l4,1446078,ignition,camshaft+position+sensor,7192
This is generic,, but will get you started..
https://www.youtube.com/watch?v=hJjA4W0s7YA
SOURCE: camshaft position sensor location
crank sensor is a component used in an internal combustion engine to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control ignition system timing and other engine parameters. Before electronic crank sensors were available, the distributor would have to be manually adjusted to a timing mark on the engine.
The crank sensor can be used in combination with a similar camshaft position sensor to monitor the relationship between the pistons and valves in the engine, which is particularly important in engines with variable valve timing. It is also commonly the primary source for the measurement of engine speed in revolutions per minute.
Crank sensors in engines are usually comprised of magnets and an inductive coil. They are principally based on the Hall effect. Common mounting locations include the main crank pulley, the flywheel, or occasionally on the crankshaft itself.
Some engines, such as GM's Premium V family utilise crank position sensors which read a reluctor ring integral to the Harmonic Balancer. This is a much more accurate method of determining the position of the crankshaft, and allows the computer to determine within a few degrees the exact position of the crankshaft (and thereby all connected components) at any given time.
SOURCE: P0344 Camshaft Position Sensor A Circuit Intermittent (Bank 1 or
The camshaft sensor is located right above the crankshaft pulley on the passengers side of the front cover of the engine. It will be a 3 pin sensor either gray or black in color. There is a pointer that is attached to the sensor and it is either gold or silver in color. There is also a recall out on this camshaft sensor. If the color of the sensor is black then it should qualify for the recall. If you get in touch with a Ford dealer they should be able to help you with your recall if the sensor is black since it is a safety recall. As far as your exhaust pressure sensor it is located on the front of the engine right by the heater core hose a little to the passengers side of the center of the front of the engine. there will be a tube attached to the bottom of the sensor that goes from it to the front of the exhaust manifold on the very front of the passengers side exhaust manifold.
SOURCE: I cant find a detailed picture of where the location is to check these items.
The crankshaft position sensor is located on the transmission bell housing on the right side (if you're facing the engine from the transmission side). The camshaft position sensor is towards the top center of the timing cover on the front of the motor. They both have 3 wire connectors that are virtually identical.
SOURCE: Where is the camshaft position sensor located in a 2001 VW Passat
when you are looking at the engine pull off the plastic cover on top then the front cover that covers you timing belt there is a wire harness tha goes right to it in the left upper coner two ten mil bolts and it comes off careful not to drop bolts down in belt that could be bad. it is that easy
SOURCE: i need to find out
The cam sensor is on the back of the engine, drivers side. On the side of the head, facing the wheel. Just under the rocker arm cover. Only thing on that side. Four bolts to remove it.
327 views
Usually answered in minutes!
×