Location of fuel pump fuse for 2000 maxima found the fuse panel but fuses are not labeled

he fuel pump fuse on a 1991 Buick Century V6 is located in the instrument panel fuse block.
To access the fuse block, you need to open the driver's side door and remove the cover located on the side of the dashboard. The fuse block should be visible behind the cover.
Once you locate the fuse block, look for the fuse labeled "Fuel Pump" or "FP." The fuse should be a 20-amp fuse, and it is usually located in the bottom row of the fuse block, second from the left.
It's important to note that in some cases, the fuel pump fuse may be integrated into the main power distribution center under the hood. If you're unable to locate the fuse in the instrument panel fuse block, you may need to refer to the vehicle's service manual or consult a qualified mechanic for further assistance.

Most vehicles have a fuse and a fuel pump relay. The relay should be in the fuse/relay block under the hood, maybe called the Power Distribution Box or Center. Look for a cover over it with labeling of locations on the underside of the cover.

The fuse for the pump circuit is often there, too, although sometimes the fuse will be in the fuse panel below the dash. And GM cars often had another fuse panel in or under the glove box.

This would all be found in the owner's manual.

The fuel pump fuse will be located in one of the fuse boxes, either under the dash or inside the engine compartment. It will be labeled as the fuel pump fuse.

The relay is the ECM relay and it's in the fuse relay center under the hood near the battery. there is an EFI fuse alson and then theirs two more fuses after the relay ones fuel pump the other ECM. If the check engine light doesn't come on with the key the relay or the ECM fuse is blown if only the fuel pump does'nt work then the fuel pump fuse is blown or the fuel pump is bad.

these are located in the underhood fuse box
Position #16 20A* Fuel Pump Relay
position #30 fuel pump relay fuse.

first turn the ignition on but not all the way to start it. listen to see if you hear a whining noise. your trying to listen for your fuel pump. if you dont hear it then open the hood and locate your fuse box. inside the box there will be a label remember your looking for the fuel pump fuse. when you found the fuse pull it out and hold it to the light. inside the fuse you can see the contact. look to see if its one piece or you can see a burned spot on the fuse. start there then well move on to the next thing

sounds like the pump died after that filet being clogged! fuse and relay are in the fuse block under the hood drivers side fender wall. ecm-b fuse g12 - f11 is what is said the location was! hopefully this helps

1. Remove the fuse for the fuel pump (located in the fuse panel in the left knee bolster).
2. Turn the ignition key to the start position for approximately 15 seconds (this will release the fuel pressure).
1. Remove upper and lower portions of rear seat.
2. Remove round fuel pump access panel.
3. Remove fuel pump electrical connector.
4. Remove fuel pump mounting screws.
5. Lift fuel pump assembly from tank.
6. Reverse procedure to reinstall, using a new o-ring and torque fuel pump assembly to 1.4 - 1.9 ft-lb (2 - 2.5 Nm) .

The air conditioner fuse is located on the fuse panel on the battery. It's the first of the 3 fuses there.