Lift hatch on 2016 jeep won't lock - Jeep Cars & Trucks

Found this wiring diagram for lift gate, if that is what we're talking about? Not only check the fuses, check fuse circuit for voltage. Use a testlite.

what are you saying.? (must be in UK)
no keys, the keybob is dead. have 2 fobs, is best.... got 2?
change the battery in it yet, CR2032 ?
all doors dead.?
or just the fob fails to open the rear hatch and the glass button
on the rear of car, right center for glass open is dead.?

try to tell what works on car too.
like can you drive car a night?
all else AOK????????

you lift out , all by self>?
or only clicks, when you , push the fob open button, or door switches?

Is it the back hatch? Can you pull the rod on the broke side & pull handle at the same time?

You have a SHORT, check for chafing of the wires...

Mine did this too....the latch kept getting stuck. If you put the key in the ignition and unlock the power doors, pull on the gate door (don't open it, just enough to release the latch), and it should come out so the hatch will latch.

you have too unlock the alarm by turning one of the door locks try them all even the hatch as they are all different

Did you remove the safety clip that stops it from collapsing during installation? Some of these need to be installed compressed and if they extend too far out they will lock up. I would remove the support, compress it at least halfway and then put it back in place with the hatch halfway closed if possible. Then lift the gate and see if that helps in the operation. This assumes you are talking about the spring tension Hydraulic lift bar on the hatch and that you can reach the connecting points with the hatch partially closed.

test the lead to the lock actuator see if u get voltage (u will have to chase wire back to fuse box to find short) , if u get voltage then the lock has gone bad or is binding on something.

Try turning the door key in the rear door hatch lock, lock-unlock-lock. That should shut down the factory security system.