If this is a manual transaxle the reverse lamp switch is just behind the battery box beside the slave cylinder mount. if this is an automatic transaxle it is built into the trans range switch that shift cable moves on top of transmission.
SOURCE: How to replace headlight bulb hyundai elantra 2004
yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx
SOURCE: 2001 elantra master power window switch
at the bottom and top of the switch there are retaining tabs. you can try to pop it out at those points with a flathead screw driver, but it is sometimes easier to just remove the door panel to get it out.
SOURCE: 2004 hyundai elantra that surges violently 1000 rpm to 4000 rpm
could be afew things. vacuum leak, one dud HT lead, could be the water temperature sensor, O2 sensor, best to get it checked and get it read for fault codes
SOURCE: How do you replace the brake sensor switch located
just un plug it and twist out.install new and adjust.
SOURCE: How to replace 2004 Hyundai Elantra starter
First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.
102 views
Usually answered in minutes!
×