Question about Jeep Cars & Trucks

Open Question

I have a blade X-r2.0 4x4 battery powered kids Jeep when you push the peddle it just continues to start and restart won’t move

Posted by on

Ad

4 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

dan

  • 651 Answers

SOURCE: 96 Jeep Grand Cherokee wont go into reverse

chheck your tranny fluid. if it's ok, probably need tranny work done.

Posted on Jan 10, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: Spinning sound when pushing gas peddle, sitting

Mine was low oil, it was making this spinning sound, i added oil and it went away right away.

Posted on Jan 16, 2010

brianfmckone

  • 1 Answer

SOURCE: I ran my jeep radio

same thing happened to me last night. Looking for an answer online like you. If you find one, please e-mail me at brian.f.mckone@medtronic.com. thank you very much.

Posted on Oct 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My rear wiper will not contact the window enough to clean properly.


get it serviced.
its cave man simple, motor,arm blade. im blind so cant see bent.

if the arm is bent by kids, it will never work right.
the angle is critical.
blade is not arm.
any shop in the world this is childs play
any auto store, will do this for free, guy walks out (kid)
and looks , the arm is bent, says go to jeep . and is right.

Dec 24, 2014 | 2004 Jeep Grand Cherokee

1 Answer

I ran over a big rock in the road. It went under car and hit undercarriage. The car engine stopped and would not restart like it was't getting gas.


trace your fuel line from your carb back to fuel tank, sounds like you have a severed fuel line. in either primary or return. it will start on starting fluid but won't continue to run without fuel.

Nov 14, 2012 | 1996 Lincoln Continental

1 Answer

My 1988 dodge Dakota 3.9 3 speed automatic 2 w Dr.idles rough and sometimes dies at a stop light and won't restart unless I put the gassed peddle to the floor.when it does finally start I have to keep...


Replace your hose going from intake to brake booster ( vacuum leak) check all other hoses also. Clean the throttle body. And a tune up probably wont hurt either.

Jun 09, 2017 | Cars & Trucks

1 Answer

Gas peddle won't produce rpm's. kind of a rough idle. Vehicle will move when put into gear and brake released but pressing gas does nothing.. (automatic)


did you check and see if the cable snapped for the accelerator, have someone push the peddle a few times and you watch to see if the accelerator lever that the cables connect to move if not they obviously broke and need to be replaced

Aug 26, 2011 | 2000 Volkswagen Beetle

1 Answer

Tail lights won't go out, even when van is off. Help


Look under the dash, follow the brake peddle untill you find a switch, it's the brake light switch, try adjusting it (it moves in and out of a plastic insert, may take a little pressure to move) there should be two wires that connect to the switch, when the brake peddle is not in used the switch breaks the circiut, push the button on the switch, brake lights should go out, if not, check for power, replace if nessasary

Aug 12, 2011 | 1999 Ford Windstar

1 Answer

I ran my jeep radio until the battery died. I jumped it and it started but the Electronic Throttle Control light came on and when I push the gas peddle nothing happens. I replaced the battery and still...


same thing happened to me last night. Looking for an answer online like you. If you find one, please e-mail me at brian.f.mckone@medtronic.com. thank you very much.

Oct 20, 2010 | 2007 Jeep Wrangler Unlimited Rubicon 2...

2 Answers

Won't stert without a PUSH START


check there is voltage going to the starter motor solidnoid from the ignition swithch when the key is turned.also check continuity from earth from battery to engine. If all fails try getting jumps leads and put one from battery neg to to engine and the other from battery pos to pos connection of starter motor. that should turn engine over. This should help you figer out whats going on. but be carefull.

Jun 01, 2009 | 1989 Jeep Wrangler

1 Answer

96 Jeep Grand Cherokee wont go into reverse


chheck your tranny fluid. if it's ok, probably need tranny work done.

Jan 10, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85219 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...