Cars & Trucks Logo

Related Topics:

L
Loretta white Posted on Oct 06, 2019

Power locks and power windows stoped working after we had a full day of rain on a 2001 Oldsmobile silhouette

1 Answer

bill1182

Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

  • Contributor 5 Answers
  • Posted on Oct 07, 2019
bill1182
Contributor
Level 1:

An expert who has achieved level 1.

New Friend:

An expert that has 1 follower.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Joined: Sep 20, 2010
Answers
5
Questions
0
Helped
2097
Points
24

Is your car battery working fine? Are you able to start the car? Check for any blown fuse. Power windows may also stop working temporarily if the car is submerged in water. Was you car submerged in water? Let the system dry, it should start working normally if fuse is not blown.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Aug 25, 2008

SOURCE: 2001 Jeep Grand Cherokee Laredo....power

I have a 2000 Jeep Grand Cherokee the power windows,power seat , door would not lock , and the inside lights would stay one ..i thought it was a fuse problem but no fuses for that ... in the rubber boot between the door and frame ..the was the ground wire was split ... put a **** connector on it everything works great now ....

Ad

Anonymous

  • 160 Answers
  • Posted on Nov 27, 2008

SOURCE: 2003 Oldsmobile Bravada interior power equipment not working

yes they do its sounds like a relay for the acc. side of the ing switch

Anonymous

  • 6982 Answers
  • Posted on Apr 08, 2009

SOURCE: vehicle is overheating...2000 oldsmobile silhouette

It's possible you have a blown head gasket. In that case, the heater core which is above the engine fills with exhaust and stops working. To verify this condition, check exhaust for excessive white smoke. If leak is still small, it's possible you won't see much. In that case have a shop check the radiator for hydrocarbons (exhaust). If the test shows any in cooling system, you definitely have a head gasket problem.
I'd also check the thermostat. Sometimes it can give similar symptom but more often than not this will trace back to the hg.

Jack Resendes

  • 123 Answers
  • Posted on Apr 22, 2009

SOURCE: power windows won't roll up or down?

could it be the contacts on the switch are burned ?
place a voltage reader to see if there is power going to it
I bet the switch is gone

Julian Boudreau

  • 52 Answers
  • Posted on Jun 11, 2009

SOURCE: back windows stoped working-then front windows and

at times in the drivers side door where it opens there is a boot. A wire may have corrosion on it , and possible snapped

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Clicking in fuse panel

put it in a garage with heat and open it up for 3 days to dry out
0helpful
2answers

Can't get rid of Power Steering noise on my 2001 Oldsmobile Silhouette

You haven't described the noise or whether the noise increases when the pump is under load, or perhaps that is the only time it makes a noise?

As you undoubtedly know some noise is natural when a fluid is being forced through hoses and orifices under great pressure and some systems are noisier than others, especially when the steering is on full lock and all the surplus pressure is diverted through the relief valve.

Perhaps there is an inherent fault that is causing the fluid to become aerated or perhaps it is something more basic and the drive pulley alignment is off.
Perhaps it is a matter of poor routing of hoses and pipes transmitting normal noise into the body and amplifying it.

I believe there are additives available that can help lessen some of the noises of complaining oil.
1helpful
1answer

Olds Silhouette Passenger Side wiper not working

Your wipers have a transmission of its own. It is located between the wiper motor and the wiper arms. the linkage to the right wiper arm has fallen off. More than likely you will need to replace the transmission. If the wiper motor is original, replace it at the same time. Sometimes you can buy the two together. Any other questions, feel free to write back, good luck.
0helpful
1answer

I need to know what type of belt is on my 2006 silhouette

You need a good repair shop- like you found several
good doctors years ago
0helpful
1answer

Leaking power steering unit on 2001 oldsmobile silhouette

You could try adding power steering fluid and see if it makes a difference. If not, then you might want to replace the assembly
----------------------------------------------------------------------------

Heavy Duty Truck Diagnostic
Allscanner VCX
0helpful
1answer

POWER LOCKS DO NOT WORK

check for power at switches, check for blown fuse, get wiring diagram and trace the power til you find it
0helpful
1answer

Power lock doesnt unlock

Just on one door? Maybe a bad solenoid in that door.
All the doors don't work? Look at your interior fuse panel. There should be a small metal fuse. Maybe two (one for power windows). That is not a fuse but a circuit breaker. Pull it out to reset it and reinsert it. There may also be a relay. Not sure where but I think it is behind the passenger kick panel. I would check the other things first before the relay.
0helpful
1answer

My 2003 oldsmobile silhouette front wiper blades have stoped working several times. The screw that holds the wiper arm to the motor keeps coming loose. Is there anything that will help. We have replaced...

You can replace the nut with a locking style nut. Your local hardware store should be able to provide you with one.
You can also purchace a small tube of "lock-tight" (brand name) that you apply to the threads then tighten the nut. Once the lock tight has dried, the nut will not come loose.
Good luck.
0helpful
1answer

2001 olds silhouette non functioning alarm

red light? this is a factory alarm?? Is GM on the key fob? factory alarms dont have "motion sensors" and very few aftermarket alarms do. roll down the window and set the alarm, now open the door and see if it lights off.
3helpful
2answers

2001 Oldsmobile Silhouette....Power lock on my power door doesn't come up completely and the door doesn't open with or without the button. What can I do? I also believe my van has other electrical issues...

From the back of the front door slide your hand in the sliding door crack and find the child-safety-lever. Push the lever up and/or down while moving the sliding door manual lock/unlock button to the up position. Also works on the non-powered sliding door.
Not finding what you are looking for?

59 views

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

john h

Level 3 Expert

29494 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...