1992 Buick LeSabre Logo

Related Topics:

Anonymous Posted on Sep 16, 2009

Im not geting any spark.its turning but not cranking up

1 Answer

Anonymous

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Master 321 Answers
  • Posted on Sep 16, 2009
Anonymous
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Jun 12, 2009
Answers
321
Questions
2
Helped
146846
Points
1053

It the ignition module pack or the crank sensor or the cam sensor.i beleive the packs are under the ignition coils.you can take out the ignition module and run it up to autozone for a free test.

hope this helps
jm

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have an 88 mercury grand marquis sterted drove all day went the next day car wouldnt start someone told me timeing chain jumped replaced that replaced starter selinoid stater spark plugs router router...

Lets start at the beginning.
Did anybody check to see if the timing chain was really in need of replacing ?
Did you replace the starter and solenoid because it would not crank ?
Is it now getting spark to the plugs, and fuel to the injectors ?
Are the injectors getting voltage and a ground signal from the computer ?
Do the cylinders have proper compression ?
Is the rotor in the distributor turning when you crank the engine ?
0helpful
1answer

My 1995 jeep jy would crank but wont start its geting no spark and no gass and it wont tell me any coulds

Does the check engine light come on, on the dash, when you turn on the ignition, before trying to crank? If it does not light up, then your ecu might be in need of repair.
1helpful
1answer

No spark wont turn over

Possible failure of either crankshaft or camshaft sensors. Have you run a scanner on your computer to see if it points to anything? Good luck!
0helpful
1answer

Just cranks over geting fule has spark plugs wet 1/2 tank of gas

test to see if you have spark with a dry plug if so you may need to dry your cyl out due to you may be dumping to much fuel. a soaked plug will not spark.
0helpful
1answer

Cranks but wont start

a host of reasons,
  • check if you have a spark buy removing ht lead from spark plug and holding near metal pat of engine while cranking, use insulated tool to hold lead, if spark thats ok
  • remove spark plug after lang cranking and smell if gas is present or plug is wet, if wet you are geting fuel
  • then ask again once you know what is not happening
  • has it electronic ignition
  • has it fuel injection or carbs
0helpful
1answer

Dodge d50 will not start

if distributor components + coil look good problem could be in the power module.
0helpful
1answer

Car cranks over but will not start

im not 100 percent sure , but if the car has an imobiliser sometimes if your car battery has lost a lot of charge the car will crank over , but will not have enough power to disengage the imobiliser. try jump leads to another car and see how you go .
Not finding what you are looking for?

232 views

Ask a Question

Usually answered in minutes!

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...