1999 Acura. Are the 1999 Acura headlight lenses interchangeable between a CL & TL models?

SOURCE: Check Engine light on Acura TL 3.2 1999

You can turn off the Check Engine light by either disconnecting the battery or by using a code reader to clear the codes. However, if the problem still exists it will come right back on. Instead you should get the code read, find out what the problem is, and fix it. Your local autozone or checker auto parts store will read them for free.

SOURCE: trying to replace a front headlight bulb on 2001 acura 3.2 TL

Look for the end of the wire retainer clip. Unhook it and lift it up. Remember not to touch the bulb. But if you do, just clean it with a bit of alcohol.

btw - Here's a bit of info from a previous post of mine...
The low beams consist of three parts. The bulb, inverter/ballast and the ignitor. The bulbs usually start to loose their color long before they burn out. The inverters/ballasts either go out after a while or take a while to start up.

Before you spend money on a new bulb, try swapping it with the one on the other side. You'll need a security torx screwdriver to get the covers off of the back of the lights. Don't touch the glass bulbs. If you do, just clean them with a bit of alcohol.

If the problem stays on that side, try swapping the ignitors. They're mounted inside the black covers.

If the problem is still on that side you've got a bad inverter. They're mounted on the bottom of the headlight assembly. You'll need to remove the front bumper and remove the headlight assembly to get to it. (I recommend you take pictures as you remove things so can put them back together correctly.)

SOURCE: How do I replace my 2003 Acura TL passenger headlight assembly?

You will have to remove the front bumper to get to the bolts that hold the head light on
I would not recommend you try this unless you have some experience with this type of work

SOURCE: how do you replace headlight for 2003 acura tl and how much does

The low beam on my 2003 Acura 3.2 tl is burning pink? How do I fix tis?

Marvin

• 85242 Answers
• Posted on Apr 23, 2010

SOURCE: can i get to fuel pump on 1999 Acura TL from back

Below are the proper steps to removing your vehicle's fuel tank..



Disconnect the negative battery cable.
Relieve the fuel pressure
Remove the rear seat cushion.
Remove the plastic grommet from the floor pan.
Detach the fuel pump electrical harness.
Disconnect the fuel lines from the fuel pump by compressing the tabs on both sides of each nylon push connect fitting and easing the fuel line off of the fuel pump.
Raise and safely support the vehicle securely on jackstands.
Remove the muffler mount.
Remove the heat shields.
Remove the fuel tank cover.
Remove the drain plug and drain the gasoline into a approved container.
Disconnect the fuel lines and remove the fuel filter and base.
Loosen the fuel tank filler pipe clamp at the fuel tank.
Support the fuel tank using a hydraulic jack and a block of wood or other suitable device.
Remove the two fuel tank support strap bolts and position the straps out of the way.
Partially lower the fuel tank to access the fuel tank filler pipe vent tube and disconnect the vent tube and filler pipe from the tank.
Disconnect the fuel vapor tube from the tank.
Lower the tank from the vehicle.
Installation is the reverse of the removal procedure.